What Have You Done To Your 3rd Gen Today?

Holy shit I forgot all about those!

 

Jumped head first into alpha rack wiring to wire in rock lights, prewire 40” BD S8 lightbar, route GMRS radio antenna.

For the GMRS:

• Main hub/box behind dash
• RJ45 jack/switch blank in lower switch panel below AC controls
• Mic holder on 3TPAM
• Antenna cable out front and up driver windshield
  • Concealed with KC Wire hider loom
• Jeep JL/JT antenna mount
  • Mounted to roof rack
• Stealth antenna

For rock lights/light bar prewire:

• lots and lots of 18-20 ga wire
• @upTOPoverland rack harness
• Wiring across to passenger side rock lights
  • Wire pairs twisted and tucked into existing bar channels
  • Secured in channel with modified windshield washer tubing
• DT connectors
  • 8 pin connector (all four Rick lights) daisy chained to create single power and single ground wire in
• Harness/loom made for 8pin rock lights and 3pin light bar wiring
  • Ran down back under weather seal to back cab wall
  • Ran under carpet forward to drivers switch panel with AirOnBoard switches
  • Wiring further advanced to PowerTray
  • Loomed wires
  • Lightbar should essentially be plug and play now (with addition of DT connector).

 

Indeed, He is risen!

 

Thanks man. It’s part of the family now. I was so excited to get offered the trail, really fortunate to have it to add to the collection! I have a feeling this will be ranking close to the favorite though

 

Amen!!!

 

TVD center consol chrome trim delete / blackout

 

Thank you Sir. I appreciate that.
Zim

 

Dash illumination? Did you find it?

 

New light bar.

 

No. I cannot identify the fuse.

 

Installed Diamondback Tonneau on '21 SR5. The thing is rock solid.

 

Couldn’t stand the rubbing so had to do the viper cut. Didn’t end up using the hole saw bit. Used the tape dimensions to get each side the same. Happy with the result and huge improvement.

 

do your flashers work?

 

Looks awesome.

 

I'm lot sure which one it is either. There are 2 fuse panels if you didn't know? The best person I know of on here to identify an electrical circuit on Tacoma's is @caribe makaira

 

I like that!!!! Very nice!!!

 

What tail lights are you running ?

 

How much of a job is it to apply that ceramic coating?

 

Dash Illumination is the "PANEL" 5 amp fuse in the cab fuse panel.

For your Turn signals is the 15 amp HAZ.

 

I believe the HAZ is the 15 amp fuse, not the 20.