What Have You Done To Your 3rd Gen Today?

No. I cannot identify the fuse.

 

Installed Diamondback Tonneau on '21 SR5. The thing is rock solid.

 

Couldn’t stand the rubbing so had to do the viper cut. Didn’t end up using the hole saw bit. Used the tape dimensions to get each side the same. Happy with the result and huge improvement.

 

do your flashers work?

 

Looks awesome.

 

I'm lot sure which one it is either. There are 2 fuse panels if you didn't know? The best person I know of on here to identify an electrical circuit on Tacoma's is @caribe makaira

 

I like that!!!! Very nice!!!

 

What tail lights are you running ?

 

How much of a job is it to apply that ceramic coating?

 

Dash Illumination is the "PANEL" 5 amp fuse in the cab fuse panel.

For your Turn signals is the 15 amp HAZ.

 

I believe the HAZ is the 15 amp fuse, not the 20.

 

Yes, 15A...

 

Yes, everything works except for the door panel and dash switch illumination.

 

I have a set of covers coming in and am trying to decide if I want to keep the back plastic exposed. Haven't looked at it yet but I'm assuming it just snaps on. Did you just cut slits for the clips to slip through or was it more involved? Would love to see some pics if you have any.

 

I’m installing a couple additional USB outlets. Besides ‘USB’, what’s a good circuit to tap for power in ‘Accessory’ mode?

 

My bad was looking at a different fuse diagram. Could always just pull them one at a time and check with a multi-meter

 

Installed an ARB compressor using the Running4Tacos behind-the-grill bracket with modified mounting hardware...

 

Door panel illumination is on same circuit as dash illumination...

 

Installed full set of CBI skids powder coated in TRD gray...

 

Installed the CBI ham radio antenna mount...