Alabama thread!

Yea I thought about doing my wife’s 4Runner and could put all that on mine but these stoptech slotted and trd pads should do good enough.

What color is that she’ll just thinking lol

 

If you can use the shell, you can have it. I was gonna cut it up for the tubing to make stuff like my fridge holder and camp kitchen thingy. I even have the keys for it.

 

I was just thinking about it for the rc but then it kinda voids the point of the rc for a work truck, but could make a sweet camping rig.

 

I want to make a platform thing for this.

 

It gives almost 4ft of space from the floor to roof

 

1 1/2” square? What gauge?

 

Sup Trey

 

Well short answer no, cause my welder only does steel lol. If I had a mig that did aluminum then yes haha

 

1x1 1/8

 

Found the limitations of this titanium. Hard not to blow through the thin stuff. Making progress though.

 

What is that?

 

Braze it and use these with rivets

 

It's a military drone holder. It was in a Hardigg/Pelican box.

 

Damn that would be pretty complicated lol

 

That's how I built my fridge holder for the truck. It's still holding together......so Imma call it a win

 

Looking good. Are you gonna plug the ends, or is that necessary?

 

It will be covered up with plywood siding so you can’t see it lol

 

Gotcha. I just didn't know if you "needed" to cover the ends. You gonna have it finished for the GAT so I can check it out?

 

1/8” isn’t necessarily thin. 80% of your sliders is likely 1/8”. You just need to adjust your settings and speed to it.

 

Sup Trey