Colorado B.S. Thread

This is something I need!! Twisted up my stock rear portion, aft of carrier bearing and had it re-sleeved but not heavy duty. Are you doing both pieces of rear drive shaft in .120 dom or just aft of carrier? Thanks

 

Anyone in noco have a spare driver side lower control arm for a second gen they would be willing to part with?

 

@Sub-Zero ?

 

Buddy of mine snapped an arm driving through Wyoming. Trying to find a spare to bring out to him

 

Where at in wyo?

 

Not even sure haha. Said he is half way to C4 fab. So probably 2ish hours into wyo

 

A town called rusk

 

Rusk or Lusk?

I've got buddies in the Hills that may be able to help.

Edit: I'm asking around SD right now. If he's in Lusk, he's closer to C4 than he is Colorado at this point. But in the middle of BFE regardless. C4 is out of my homeland.

Edit x2: I've asked around in the WYO thread. Though, I'm almost certain most of the chatter in that thread comes from guys who aren't even in that State, aside from Monte and some dude out in Jackson.

 

I've been on a couple trips where someone had one and on a cold morning at altitude it definitely outperformed my coleman setups as the propane tanks/bottle I was using began to frost over

 

I have a LCA, but not exactly on the way to Lusk.

There's people from WY in the WY thread? Monte lives in MT these days.

 

Ha, shows how much I know.

 

This has been my experience as well. A near full 15lb tank couldnt keep a flame going on my Camp Chef on a really cold, windy night, and after fighting it for 15 minutes this overlander pulled out his fancy overlanding Partner stove that we had made fun of all week and it seemed to be full strength. I ate my hot dinner that night graciously.

Also...happy Friday everyone!

 

Just getting the aft section done

 

I have my BAMF relocation kit and 14" short bodeez in my garage awaiting time to mock up and check travel before I weld in. I see you have done this with success!! And with all the extra droop I really need to beef up the aft drive shaft section so I am interested in seeing how your new shaft works out!! LOL

 

so you might be able to get the old ass style license plate in 2022! and no longer have the option to transfer plates to another vehicle

https://coloradosun.com/2021/03/10/colorado-green-mountains-license-plate-comeback/

 

Did you go with bilsteins?

 

Yes got the bilstein 14" short body
Bilstein AK7114SB06 7100 Series Shock Absorber 33.84 in. Extended 19.53 in. Collapsed Compression/Rebound at .52m/s 800/3600 Reservoir 7100 Series Shock Absorber

 

Yes that's them! Going to be a wedding gift for a buddy!

 

Yeah I heard him wrong over the phone, it’s Lusk

I appreciate the offer, but that’s a big detour haha