1st Gen Lunchtable Thread - General Discussion

I actually have seen Primus live a couple times from way early on when they were playing small clubs in SoCal still. Mid-90s-ish.

Actually, early 90s since it was before my daughter was born.

 

Is it a two-week wait before you can declare victory?

 

Wynona Ryder tried to sue primus for that. she said it was slander

 

Same here. I saw them at UCSD we might have been at the same show

 

I guess, that's what I've heard. They didn't say anything when I was getting the shot.

LMAO!!

Never saw them at UCSD. I'm talking clubs, small clubs. There was one on Clairemont Mesa Blvd and Dianne St that they played at a couple times. I think it became a computer store later, not sure what it is now. Small hole in the wall place, just big enough for a small stage and a bar.

Correction, Clairemont Mesa and Mercury. I was on the wrong side of 805 before. Looks like it a ceiling fan shop now.

 

Looking back at a picture of the rear suspension before I lifted it and installed the Panhard angle. Then another picture with a 3.5" lift and after the Panhard correction kit.

I didn't really think about measuring it before or after. Just stumbled into some pictures and decided to compare old to new. I think I have the same angle after lift as before on the stock suspension.

 

Good idea. I'll have to mark the bar angle before I do the lift. I've got the eimkeith correction thing too. Lifts the driver side of the bar where the LC on you posted drops the passenger side.

 

As of today? Let us know how the side effects go if any, hopefully there are none. Not sure when they kick in for most

 

I'm hearing after 24 hours. So far, nothing. Got the shot at 10:30.

 

Hrm, cryo treated rotors. Should I?

https://frozenrotors.com/front_right_power_slot_cryo_rotor_126.44129csrfmhl_126.44129csr.html

 

What the...never heard of cryo treating rotors, what's it do?

 

@Abeyancer been poking away at adding a 20amp circuit off the garage sub so i have an outlet for heavier duty tools. Threw an outlet and light on the side of the house since that whole side had neither.

Thanks again for all the guidance

 

Aligns the molecules up for better wear characteristics or something. Supposedly handles heat and wear much better than non-cyro treated parts.

 

There are two adjustments on mine. I'm on the lowest level. Once I get fully loaded, I could move up to the next higher level. It sure drives better with it than without.

 

Kinda like synthetic motor oil?

 

Something like that I think.

 

Does anyone have a 220v garage heater rec?

22x24 ish insulated garage.

This one seems great especially for maintaining a target temp of 50 deg but the reviews about catching on fire are concerning

$118 Comfort Zone Hard-Wired Ceiling Mount Garage Electric Space Heater, Fan-Forced, 5000 watt, 240 volt, Overheat Protection, Thermal Cut-Out Switch, Ideal for Workshop & Garage, ETL Compliant, CZ220

https://www.amazon.com/dp/B009F1SWH8/

 

Yeah, metal has a "grain" that is visible under a microscope

Some people going hard often on Yota axles have their ring and pinion cryo treated for extra strength