What Have You Done To Your 3rd Gen Today?

Are you saying you did split the front speaker signal?

If not, you can set your rear fader all the way to the back and there will be virtually no volume.

 

They sure will.

 

I have not completed the project yet. The amps are mounted and the custom T harness from the HU to the amps I made up is done but not installed yet. This is the setup mounted on the back wall.

 

Makes sense, I'd do the swingaway on mine, so that's a bit more weight added. Looks great!

 

I made a harness so I didn't have to splice into any wires, a lot of soldering but worth it.
No lc7i for your door speakers?
You don't plan on having any fader control?
You will essentially be listening to everything "mono" vs "stereo" without an lc7i or new headunit, right?

 

It's got the black over coat peeling off. And I have this.

 

I'm going into the the LC7i, then Y splitter out to the 4 channel amp to the 4x speakers. Also, adding 2x 6.25" subs under the jump seats.

 

Gotchya

 

I put in two of the kicker hideaway subs. Not super thrilled with them either but truly I need to swap out my head unit before I put all the blame on kicker.

 

Yeah I'll probably make a swingout in the future, but for now I'll just throw the spare in the bed for wheeling and throw it back in the stock spot while daily driving!

 

did you replace your fog lights? or put a film over stock?

 

Very nice. One small adjustment you might want to consider is flipping the aux battery so that the positive terminal is towards the engine and the negative terminal is towards the sheet metal. This is the recommended configuration in case of an accident, the sheet metal fender would be better off getting pushed into the negative terminal of the battery and not the positive.

 

Put on some Falken Wildpeaks and put them to the test hauling about 1500 pounds of mulch.

 

Who else does the OV Tune in the DFW area? One person told me that Chris Marsh at Apex Automotive in Addison does it but no contact info on him yet? Got some questions about it.

 

https://www.tacomaworld.com/forums/texas.46/

 

Painted my own push start/4x rings. Still kinda looks like chrome in the picture

 

RCI 5* Kickout and top plate

 

Broke the black bracket on the passenger side headlight when taking them out. Can't be more than a $20 part or maybe I can just get a washer in there. But getting the headlights done tomorrow.

 

Milwaukee saw blades are quite good



Also secured the diff breather hose with a 1/2" nylon clamp, since the bedside brace was removed:

 

Thank you because I have been thinking about getting some bezels for the Tacoma but the item only goes up to a 2018. Here is the link: Triple Chrome Plated Taillight Trim Cover Bezel for 16-18 Toyota Tacoma | eBay which is the same picture as the ones sold on Amazon

$76 Razer Auto Triple Chrome Plated Taillight Tail light Cover (Chrome) for 2016-2017 Toyota Tacoma

Amazon.com: Razer Auto Triple Chrome Plated Taillight Tail light Cover (Chrome) for 2016-2017 Toyota Tacoma: Automotive. Just wasn't sure though.