What Have You Done To Your 3rd Gen Today?

https://www.ktjo4x4.com/tacoma-power-outlet-2016

 

When you replace it check to make sure that the sillcock is sloped downward from where it is connected. I have had the same problem and had to do the same repair. If you have a basement it might not be too bad. A crawlspace? Then it really sucks.

 

Installed a Voswitch Switch Panel in my truck! Super easy install and makes the wiring super clean compared to before.

 

I'm considering swapping out the halogen low beams and fogs for LEDs. I don't want to blind oncoming traffic. Can anyone recommend a brand/model that is configured correctly to be used as a halogen style reflector beam?
TIA

 

Yep, it counts. Who needs A/C when the wind is blowing while going down the road.

 

Nothing. Leaving it alone.

 

Yeah.

 

Fixed the wire harness for the gear selector lights.

 

Consider the OEM LED fogs as seen

$134 Toyota Genuine Parts - Led Foglight Black (PT413-42191)

here. They're pretty nice! And, no LED in the headlights, please. Only brighter halogen bulbs. Unless, of course, they're OEM LED headlights. GL!

 

Post that scoop hood on the hood-swap thread and see if you get any takers.

 

Thanks for the info! Those fogs should do the trick. That's what I was afraid of re: LEDs in the headlights. I'll look into brighter halogens. The stock headlights are pretty anemic.

 

Great info for sure. I really appreciate it I’ll dig in later today and see if I can find any. I’ll check and see if anyone local has any too. In DFW

 

Check out this post here

 

People get rid of chrome because of glare? I just thought it looked tacky...

 

@crashnburn80 Did you have a recommendation for 3rd gen H11 low beam bulb replacement? Thx!

 

It does. And it’s not chrome. It’s plastic. So even more tacky.

 

Manual

 

Been doing a few minor things to my 21 SR

Not just today but meaning to post a few!

-OEM Bed Mat
-LED interior light conversion including licence plate and reverse bulbs
-Complete de-badge
-Upgraded halogens
-Weather tech in channel rain guards and hood deflectors
-Weathertech front and rear mats
-17"TRD Wheels
-265/70/17 BFG KO2s

Still to come:
-Bak MX4 tonneau cover
-Bilstein 5100/5160s
-Progressive AAL for 1-1.5 rear lift and extra load support

 

That's interesting. I figured most aftermarket wheels pretty much pushed the tire out more than stock. I just got the trd pro wheels and they push the tires out right to the hairy edge of the wheel wells. I think the wider stance looks good on it. Go fot it!