What Have You Done To Your 3rd Gen Today?

Installed around 2 square feet of left over Dynamat that I had from my son's car. I started early this morning to beat the heat but what should have taken an hour to do both sides took over 3 hours because I did not want to break any of the plastic fasteners in the fender liners. Hopefully, this will reduce some of the tire noise on the highway. I now have 97 square feet of Dynamat, Dynaliner, and Dynapad along with 55 square feet of closed cell foam and 12 square feet of open cell foam so it is a pretty quiet truck. None of the interior pins or clips were as difficult to remove as the fender liner ones and if I were ever to this job again I would buy a bag of new ones and drill out all of the old ones and replace them with new ones.

 

What kind of water pressure do you get from that pump when you use the nozzle?

 

Was wondering if anyone has done a tutorial (or knows of one) on removing the back (under the back window) molding/ trim on an SR by any chance?

looking to do the sound deadening back there.... right now it’s just sitting in a box.....

 

Installed 2017 TRD pro headlights. Such a noticeable difference

 

Looks good!

Aren’t 17 pro fogs Ridgids?

 

Got my Cali Raised 40” prinsu bar up and wired in. Added the lamin-x film for the yellow.

 

Yes. But this isn't a pro

 

Im confused.

You said you installed 2017 trd pro fog lights, which are Ridgids.

 

I believe he stated headlights not fog lights.

 

Sorry guys, I’ll just stfu now.

 

Bwaaaaaaaa....

 

Replaced the OEM fogs with DD SS3. Super easy. Took about 15 minutes.

 

Ordered a MESO Overhead Hex Rack

https://mesocustoms.com/products/ov...n-tacoma?bis_id=pk3aad&variant=31337766256753

 

Have not tried it yet, ad on Amazon says 120 psi.

 

I ran a constant 12v plug into the bed cubby on a switch a while back for my fridge. Water source is just a 6 gallon igloo container from Walmart.

 

Just came back from the shop. The tech was able to straightened my steering wheel. Cool!

 

Dropped the truck at the dealer for a recall swap of the low pressure fuel pump.

 

Meh, mine is going in on the 20th for the same job... good luck m8!

 

Me too! Got the available email while sitting in the car and had to complete the order before dropping the clutch. No clue how long they’d last.

 

E-mailed my local library with the URL. They responded the cost to print would also be $3 and would be ready by end of the week. Thanks for the great idea