Colorado Trading Post

Yeah they’re in correctly. It was probably good and I didn’t let it settle then started fucking with it, I’ll play around with it in the daylight tomorrow am.

 

Probably tie rods. Not many people would notice camber or caster by eye

 

When we do front end work we set caster and toe. I try to make it go down the road without destroying the tire. At least give them a week or so to get it to a alignment shop.

granted we do it by eye not tape measure.

 

Same. I max caster on the cams (after calling @thefatkid to remind me where that is) then do toe with a tape measure and then take it in, usually for very minor unnecessary adjustment.

 

Yeah it’s pretty bad. I’ll try to bounce it a little and see what I can do tomorrow before I head to RSG

 

What color?

 

WTB

Looking to buy a hitch mount bike rack, preferably a rocky mount or something similar. Also would prefer for it to be for one bike. I am located in the Frisco area, but we will up in Denver this evening. Anyone on here got one they're looking to sell? Headed to Moab tomorrow morning, would love to grab tonight if possible!

Thanks fellas

 

@RtacomaN has a “Brand new in Box Yakima holdup 2” in Grand Junction.

 

I live in grand junction and have the holdup and an older Thule t2. I mounted the Yakima but haven’t registered it so you’d get full warranty.

 

I'm really looking for a single, I will shoot you a PM.

 

Thanks for reaching out. Army green ideally but black or gray would work great too. If not, can get it repainted for ~500 also but would be a tad hesitant on it haha. What do you got? PM me!

 

ISO white topper for a 2nd gen DCSB. Denver/Co Springs area

 

Hey everyone, I'm looking for a rtt. Was looking at desert Armor or tuff stuff hard shells but both are on back order. I don't think I want to spend 3500 on an ikamper mini Thinking about just picking something up for the next few months. Any body have something? Thanks

 

Anyone have two of these around? They're the riv-nuts that come with the prinsu access rack. Mine came up two short in the hardware package and I currently have open holes in my roof. No luck at the big stores or Ace. I'm in Arvada. Missing two of the spacers also but I can figure that out.

 

What size thread do you need? I have some of those in 1/4”-20 thread.

 

They are 1/4 20. I’m going to thru bolt these two for tonight since I have the headliner out and looks like rains coming.

 

@Red Baron sorry for the delay. The rack needs to hold a pair of Rad Power bikes that are about 70lbs each.

 

@Funkyninja23 Do you still have the BCM charging handle? Where in Denver are you?

 

sorry for the triple post, ISO a collapsible soft topper for a DCSB third gen. Prefer black. North/West Denver area.

 

Sorry- gone. I literally just sold it.