What Have You Done To Your 2nd Gen Tacoma Today?

Thank you for reminding me to pull and vacuum my K&N cabin filter.

 

Yesterday I de-burred & bent over the fender tabs for both front wells; and made up a front passenger well liner.





I discovered that I accidentally cut into the floor pan on both sides behind the wheel wells.



So today I sealed the cuts up with silicone & then taped them over with foil tape. I also sealed up old liner holes with the tape. Prime’d, undercoated, & painted everything.



The undercoating was still too soft to continue with the liner project. So I switched gears & relocated the rear wheel well/bed-side brackets. I used a conduit bender to modify the forward brackets; and I cut an inch off of the rear brackets.

 

Order a new one or fix an old one? If new where did you get it?

 

That's my build direction. It's taken 6 years to get it where it's @ now & tons more to come.

 

Great experience working with @discountire to replace the rims and tires on my Tacoma. Best price, very friendly and the truck was done in under an hour.
method 305s wrapped in a falken wildpeak.
265/75r16

 

Chevy 63 swap underway

 

Well, crap!!! I fixed my OEM back-up camera.....

 

Dirt farming today!

 

That's the best stitch job I've seen on a steering wheel cover. Usually they're a disaster.

 

Thanks! It helps to be a little OCD.

 

You are good to me. So I'm good to you

 

Super stoked I was able to snag a set of gloss whites. Honestly was not expecting to be able to get them but i had all my info saved on my computer and was checked out by 6:02

 

Well. Damn.

 

Replaced these with Powerstops last night. I’m glad I did as one of my rotors was cracked. No pic of new as I was out of daylight and needed to break them in. They are a great upgrade.

 

Nice upgrade! Was there a reason you decided to replace it?
I did Powerstop too, to resolve "warped" rotors. It's been great ever since replacing.

 

Did a thorough hand wash that I’ve put off long enough and cleaned the inside. Hoping to do a detail and wax in upcoming weeks before it sees the coast!

I really just need to bite the bullet and pick a nice ceramic. I’ve used Gyeon trim for plastics and it looks good as new still over a year later.

 

Thanks. A couple of reasons. I knew I would be replacing pads soon and was getting a flutter while braking, especially on long inclines, so I figured something was up. I suspect the crack in the rotor was causing some or all of that. Also just bought a 5x10 utility trailer and wanted something better suited for towing. I’ve heard really good things and the price was reasonable.

 

More of a "what have I done this last month" but:
New 6112s installed



New 5160s, shoes, and painted drums


New Yokohama Geolander MT G003 (255/85r16)

 

Twiddled my thumbs and missed it just like 3 weeks ago when I dropped it off for the frame replacement..

 

I have to ask, what is the reasoning for creating tabs along the fender?