1st Gen Lunchtable Thread - General Discussion

MP machines, in my experience suck at Stick and Tig but do fine with mig

Millers at school and my Everlast at home

 

no, I'm perfect

 

Then get better at puddle control

 

Such a beautiful sight.

 

I remember firing up my machine before school once and ruining a few electrodes but being unable to even keep an arc

Believing I was a failure at life I went to school anyway and found I could weld just fine on dedicated arc machines

 

Dude, tack some plywood scrap over that gaping ankle buster hole.
Just saying

 

Just pee in a cup, they are great for puddle control.

 

So the Ford tows the Taco...what tows the Ford?

 

Legend has it, he likes gaping holes.

 

I heard Nasty Gash

 

So I got the paperwork regarding the 3M claim.

Hmm...they're pretty good at getting everything in black and white to cover their ass 100% I mean obviously; they're lawyers.

I don't even know if I care to continue to file for it

 

You make a great point.

$3 in scrap plywood could save me a huge pain in the ass and my 5-6th physical therapy script

 

It's the first vehicle I've owned that I could put 30k on without major repairs

 

Fify

 

lo mismo

 

I guess I'm forgetting about the Yaris. It was a good car, just not a good fit. Plus the whole post breakup impulse purchase didn't sit well

 

Wife got an engine mount replaced on her RAV4 today, she took it to a shop near her old place in Hollywood. Looked at the bill and it was only $90 labor, seems way cheap to me for an engine mount replacement?

Anyway...had to take her to get the car after work, spent 2 hours in freeway traffic going in/out of the soulless hellhole that is Hollywood. Ready for a drink or 4

 

I'm not familiar with a RAV4 but I know when I did a buddy's entire front end work on his SRT4, the engine mounts (specifically the lower one), just needed to be raised slightly, have the wheel removed, and 2 bolts is all it took.

With the wheel off, it was literally a 2 minute job.