Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

Nice! Post up some action shots if you get them. I’m hoping we get back in time for me to hit my back yard whoop pit and try to get the wife to follow on the road for some footage of one of the deeper sections. Had a buddy try to get it 2 weeks ago but there was traffic on the road so I pulled ahead and you couldn’t see much.

 

did you cut your inner fenders out and relo your battery ?

 

You're not alone. Set this on the ground last night and just picked it up from alignment 30 min ago. Heading up the 395 tomorrow morning for a long weekend getaway.

The truck has been on jack stands since mid-Feb. Did the LCA relocate and the +2.25” LT kit along with a bunch of other stuff.

 

Awe shit it looks like at least a few of the other users and abusers of truck parts are finally getting their shit back together to play.

And your winch line is loose too. What’s with you winch people

 

It’s there for looks. It’s not wired up and won’t pull shit. Do I get broverlander points?

 

I’ll allow it. Just trying to get some extra weight up front to balance things out I suppose

 

Hope these will keep the tranny cool

 

You might wanna trim that glass, unless you already cycled it.

What coolers? Mine looks the similar, Iv never got my trans over 180° With fan kicking on at 180° with a thermostat and I like to redline it everywhere lol.

 

Where you gonna put the toilet paper and paper towels from Costco?. I know your not rich enough anymore to buy lumber after cutting off the front of the trekker...

 

They are the bigger version of what you have... each one is 12”x15” w/ 800cfm fans

 

Wish I had gone bigger. Where are you running the lines, off the trans or still using the radiator?

 

Right off the trans, trying to get as much heat away from the intercooler as possible

 

Inner fenders will be cut as needed Saturday too. Battery was relocated awhile ago.

 

Curious of why you say that. Did you have problems with your +2” glass?

I did cycle with the tire on but not for that purpose so could have been overlooked

 

I didn’t have any issues with my +2” glass and the 35’s. You’re probably fine

 

Ah cool was wondering how you were gonna’ mob it. I was able to make some straight runs down a fire road around 50mph but i’ve got to wait to play until i get the inner fenders installed next month. Front end felt awesome though...

 

I had to trim a lot up front when I went to 35s. Could also be my offset too though but when I cycled mine it didn’t look like changing offset would help too much. You can see how much I trimmed by looking at the lines on the right. I mainly rubbed up front where the plastic bumper meet. Even at full bump with 33s.

 

made you running hrdros up front?

 

I had to hack the fenders pretty good to stuff the 35’s... use this pic for reference