What Have You Done To Your 3rd Gen Today?

It took 5 months to get the thing and another few weeks to prep and coat.. but the bumper is finally on. Winch and light bar to be set up tomorrow. Bed molle panels next.

 

Huh, I have yet to install mine because I’m not done work inside the tailgate but I didn’t think of installing underneath the panel- that’s great. Any issues under the m hatch? Did the screws go through the seal?

 

I have Resonix inbound, which is a better product than Noico but essentially the same stuff you’re suggesting. It’ll have to wait a month for install, but that’s ok. I may circle back down the road and do a full on sound deadening with lead, we’ll see. Pretty happy with the sound already tbh

 

Any details/pt #, this looks interesting. Assuming since still Toyota that steering controls and menu/settings and mic are still intact and mic is stock? Fits directly into dash no modifications? Is the cam resolution any better or same

 

Linex? Oh, I saw your previous post... nevermind. Looks good!

I installed a Hiline bumper recently; and just wiped the whole thing down with 91 percent alcohol and then expelled a can of flat black Krylon enamel spray paint on it. Just to help the powder coating resist corrosion, I plan to Fluid Film the interior portions of the bumper before winter arrives here, with the brine and salt Maryland loves to put down on the roads.

 

Those are not chrome.

 

What I did was purchased a QC3.0 dual USB port and connected it to the fuse panel under the cubby/switch bank to the left of the steering wheel using an add a fuse connector. I then just zip tied the dual USB port under the dash so it is out of the way. I then plugged the usb cable into it. I do need to come up with a better location to zip tie the USB port to under the dash, but for now this works. I’m sure my sloppy wiring will drive many people nuts though.

I purchased the from The Taco Garage.

 

Installed Cali Raised items:
-Premium roof rack glad I choose it can’t stand the wind noise
-Rock slider /kick out
All items solid @CaliRaisedLed

 

I just got the same one, didn't know about the koozie mod. I'll be doing that too.

 

It does a good job of keeping it snug in the cup holder.

 

Nice. I just bought the 8 gallon one. Should be here next week. Have you filled it yet? Does it really auto-pressurize? All the videos seem to imply that.

 

Yes you connect the hose to the tank and it works well. The hand pump doesnt work as well but still pretty good. It has a schrader valve which is nice as well

 

I have not figured a good way to mount mine. I have a molle panel, but already have my shovel and ax mounted on that.

 

I installed a tonneau cover and remote tailgate harness!

I noticed something odd I hadn't seen before though. The instructions for the wiring harness say it should be ran alongside the reverse camera wiring on the passenger's side but it seems the camera is ran alongside the tail lights connection harness on the driver's side. Had to end up tying down the wire alongside the brake line then over and at the frame until I was able to tie it to the brake light harness. It does sag some where I threw it over the frame, I will need to find a way to fix that in the future.

 

Pioneer 6600NEX installed. What a difference! Highly recommend doing this upgrade.

 

Added LED interior lights…Amazon
Added Total Chaos Bed Stiffeners
Added Yakima Overhaul HD rack!!

productive weekend!

 

Adding the hideaway sub/amp today. Pleased with the way its fitting in

 

Very nice!!!