What Have You Done To Your 2nd Gen Tacoma Today?

I got them at hid retro fit kit

 

Gave her a good wash & then installed some @81Trekker JD FAB UCA on my buddies truck. These control arms had us drooling. They are seriously impressive and without a doubt beefier than my total chaos ones. Within 2 hours we had both sides done, it went pretty smooth

 

I'm still out & about in Idaho, back in civilization now. So far the only casualties have been a zip tie holding my fender liner up, my buddy's battery's in his cummins & some black bears.

man, idk if I wanna go back to PA.

 

My front zerk is the same. I removed the stock angled zerk and replaced with a straight one. I'm then able to access it with a 90 degree grease gun fitting that is shaved down a bit. I tap the fitting onto the zerk (carefully) then connect the grease gun to the attachment.

 

Finally got around to sewing on my steering wheel cover, really impressed with the quality

 

did you use the Loncky kit? i did, took a few hours and some sore fingers but came out well. yours looks pretty clean.

 

Awesome, here are the ones that I went with.

 

I ordered a needle. I'm going to just do it the slow way. My 90* flat wouldn't fit in there, even shaved down, and the needle was $10 vs a 90 degree straight that may or may not fit.

 

Hope it works for you. I tried it but could never get it to work properly.

 

I used this one: https://www.eastdetailing.com/collections/infiniti/products/copy-of-2012-2017?variant=29384551858291
Instructions weren't great, but the fit is nice

 

Was driving down a pretty rough road and found out how much my cabs pinch welds actually contact the new sliders. Sounded like something way worse had I not just installed the sliders and knew they were close to touching. Now I am debating trimming the pinch welds and risking rust later down the road or biting the bullet and redoing my cab mounts with energy suspensions mounts and sliding in a toytec 1" body lift while I'm in there.

 

@Dzzysbrother

 

does it drive okay? I have it at D and beat the shit out of the cab mount and re welded it and it clears fine now. Well see how trail use goes.

 

Met up with my Dad to get the bikes out.

 

literally was just thinking about this
How did you do it ? Youtube ?

 

Ya, just watched a couple videos. It's pretty straightforward, just take your time. Toughest part was stuffing the excess material inside the wheel

 

Two regular cabs. What are the odds?

 

Ok everyone I hade an argument with my girlfriend today.....


Or...

 

The first way for the auto tension on insertion otherwise you're tilting the drink toward you to get it to work