What Have You Done To Your 3rd Gen Today?

Thank you

 

OK once again, has anyone heard from Rivetnut Bob lately?

 

In the month that I was "not here"...I have installed Carhartt front seat covers, sequential mirror signal lights by Cartrim, installed a dual USB in the rear seat area Blue Sea, hooked up the light bar by Sports Race with Cali Raised brackets, ordered an RSI EVOA Adventure cap...

 

@RallySOP, I'm way behind on this thread, but if you still have the bubble issue with the Qi Charger pd; this worked for me - at least well enough

 

@kingtone68, See if this helps, of course if you have a warranty that will take care of it, this might make them not replace it for you

 

got my lift and wheels installed last week , so I installed an alarm system.

 

Thanks, I’ll keep that in mind for next time. After a few days on the phone with the brand engagement department, my dealer magically got the parts in.

 

Got some more stickers. They should be good for more hershpers.

Let me calculate....
3 divided by the sum of this multiplied by the weight and add the cool plus two and subtract the nerd and add the dirt and (where was I?)
Yep... moar hershpers!

Oh.... I think my project pile is getting a little too big.

 

What brand and size tire did you go with? They look really good.

 

went with BF Goodrich k02 285/75R17

 

Hah - That's what I had on my 2018. I might as well stop looking and stick with the KOs Your lift and tires, wheels look well balanced.

 

Thanks! I was initially was planning on going with Toyo Open Country AT3 but it was back ordered and wanted to install the wheels right away so i just chose the KO2s

 

This is my dashboard buddy.

 

Replacement under warranty is definitely the way to go My '16 was too old

 

Nice! Was your loan for 36 months?

 

New suspension. Who dis?

 

Added some Diode Dynamics SL1 H11's in my low beams. Incredible change for a pretty low price.

 

I felt the horn on the Tacoma could use a little help...

So I installed a little 26" horn. Black so it blends in...

https://vixenhorns.com/product/vixen-horns-vxh1168b-semi-truck-single-air-horn-black/


Installed the 3/8 double flared copper lines from the compressor to the manifold and then to the horn...

the 2 RH pieces of tubing coming out of the manifold are just there to seal it off until I run the lines to the air tank with a drain, and the air hose connector.


Will paint the copper and brass fittings black so it looks more "factory" as well as the white padding in the front trumpet mount.

It's fed from an ARB twin compressor so even though it starts out at 150psi the pressure drops off quick without an air tank.

Even without the air tank installed and the weathershield on,
it is very loud similar to a truck / barge type level sound.

Standing in front of the truck and testing it with ear muffs on,
I could feel my lungs rattling in my chest for the first second.
From inside the cab the sound was muffled quite a bit ,and it was comfortable on the ears without ear muffs. Sound level was like a Semi blowing their horn beside you.

No extra holes were added/drilled, Used Unistrut for the bracket on the left side holding the horn base at the back, and a 90deg bracket on the trumpet base that goes to a rad support hole.

 

Uh oh. That’s gonna be a hefty late fee from that due date. Y2K!

 

Purchased and installed the TRD wheels. I'm not a fan of the newer look.