What Have You Done To Your 3rd Gen Today?

Thank you brothers and sisters, I defected from Romania way back in '86...here, I can't say much or else I'll get "booted" again...who ever thought that we will see times like this...but thanks.

 

Your how I found the brand! Thanks. These are not the folding kind though, i just keep them in place

 

There is also powerwerks. I started looking into the blue seas panel but then found the other and they have a variety of voltmeter sockets/plugs/etc at a cheaper rate. They have similar panel options etc. I’m still undecided on which route I’m going but figured I’d let you know options
https://powerwerx.com/

 

Nice! Where did you source the power for it?

 

Installed blue sea 12v meter with switch

 

If the squeak is by the window controls/armrest- pull the window control panel up and lay foam against the backside of the door panel where these 2 parts are closest. I haven’t done it yet but my drivers door started making noise and only when my leg is against it. Others have mentioned the foam as a fix. Now if your anything like me that will lead you down another rabbit hole on best foam for use (open/closed cell is probably the main factor to consider) it’s crazy at all the available options

 

Ran a 12ga positive and negative to the battery in split loom, and fused at 20amp.

 

You could also buy the arb frig harness (it’s 20’ 10awg 2conductor/bonded and fused). I put it in split for added protection too and disclaimer- i was short 3-4’ to reach passenger box. But it’s an option for a pre made harness and it doesn’t have to be used for only a frig

 

DesertDoesIt Multi Mount Panel - Mounted my Stinger vehicle light and set it up to charge while the vehicle was running
S&B Cold Air Intake
Oddessy 24F AGM Battery

 

Haha. Yea I thought about that but he is so tall I would have the steering wheel under my chin for him to fit.

 

Thanks. The actual sound is coming right at the tip of my finger. But I can push anywhere on the armrest or the door panel and the sound comes from that one area.

 

I had 25' of wire and loom and only cut off about 1 inch. So I would say your measurement would be accurate.

 

Does that intake use the original inlet from the fender as well as the front facing one? I always thought it would be great if someone made a kit to use the scoop to actually get air into the box.

 

Foam will be your answer imo- likely closed foam because it’s more firm (higher density or is it the other way).

 

I need to order those, they look real sharp.

 

Got new wheels! Not the fanciest, but wow what a difference they make to the look of the truck.

 

I got lost on the way to the mall with some friends.

 

I'll have to give that a shot. I'm assuming the rear panel comes off just like the front. Haven't ever taken those off.

 

Yes. S&B includes an accelerator intake to replace the stock intake in the right wheel well, as well as the forward facing intake in the right front, right of the air divider in the grill.

 

Did the bhlm and gave it a quick wash.