What Have You Done To Your 3rd Gen Today?

I had 25' of wire and loom and only cut off about 1 inch. So I would say your measurement would be accurate.

 

Does that intake use the original inlet from the fender as well as the front facing one? I always thought it would be great if someone made a kit to use the scoop to actually get air into the box.

 

Foam will be your answer imo- likely closed foam because it’s more firm (higher density or is it the other way).

 

I need to order those, they look real sharp.

 

Got new wheels! Not the fanciest, but wow what a difference they make to the look of the truck.

 

I got lost on the way to the mall with some friends.

 

I'll have to give that a shot. I'm assuming the rear panel comes off just like the front. Haven't ever taken those off.

 

Yes. S&B includes an accelerator intake to replace the stock intake in the right wheel well, as well as the forward facing intake in the right front, right of the air divider in the grill.

 

Did the bhlm and gave it a quick wash.

 

Friday front end festival was such a hit it raged on until Saturday. I finally mounted my front plateinstalled the oem led, bought from Olathe, used a harness from retrofit harnesses…. Passenger high beam doesn’t work. Anyone have any suggestions on that one?

 

I replaced the stock GY Kevlars. Not only is the tire much better looking, it's no louder, just as smooth and at least in the OE rating, the I think they ride a little better and I've picked up a little mpg. I'm completely happy with them, but I've only put a few hundred miles on them, so time will tell. I paid 530.00 to my door from DTD and 100 for install. Sold the 3 GYs I took off for 150, so cheap!

 

Craigslist canopy score!

 

Another rig for the TW Navy!

A couple trucks more and we can invade a small island nation.

 

I'm just getting started on mine. Yesterday I peeled off the "too bright for me" TRD bed decals and replaced them with the more subtle matte black decals...and added a grey scale TRD grille badge (still not sure about the badge).




This morning I got the front windows tinted to match the factory rears and this afternoon I installed the tri-fold Lomax tonneau cover.




Special thanks to GotExhaust for the hookup on the tonneau cover!

 

Me either but assuming so. I still think all you’d have to remove is the window control panel from the door itself, see how much room you have to figure out the thickness of foam needed.

 

357 on a magnet mount

 

I may give that a try first. I've never taken off the window control panel so I will look for a video on that so hopefully I don't break anything. Appreciate the tip.

 

Careful, the bullets will get magnetized and pull to the right.

 

Thanks for the link to the dashcam power connector. Ordered a dashcam last week and this will make the installation a lot easier.

 

Seat Jackers on both driver and passenger seats.

At first I was a little skeptical that they really made a difference. I came from a 1st gen so the 3rd gen seats are much more comfortable than my old truck. After talking to a couple of people, they really recommended them. I'm glad I did them. What a difference in the seats.