What Have You Done To Your 2nd Gen Tacoma Today?

Cleaned all door jambs and rubber molding .
McGuires detail spraying jambs and Citrus cleaner on the molding. Pollen and all kinds of dirt in molding .
Lubed Uni- balls .

 

have you tried this?

$33 LockNLube Grease Gun Coupler locks onto Zerk fittings. Grease goes in, not on the machine. World's best-selling original locking grease coupler. Rated 10000 PSI. Long-lasting rebuildable tool.

https://www.amazon.com/LockNLube-fi...ockn,aps,164&sr=8-1-spons&smid=A3UPOD5O08GT8E

 

Changed front and rear diff fluid. Also installed Lexus front diff drain plug.

Tcase tomorrow

 

I got started on my install for long travel. Tore down one side, cleaned it up, and welded on uca gussets. Gave everything a nice coat of paint and will continue tomorrow.

 

Yes and it will not fit into the joint, hence why I'm asking for people who have actually done it to lend a hand.

Did that somehow work for you?

 

I plan on getting one. But with my normal tip, just need to push it on and hold it in there while you pump. Its awkward, but you can get it done

 

I just use a normal gun and have zero issues. The only hassle is having to remove the heat shield on the rear of the Tcase to get to the one on the front of the rear drive shaft. Impossible to get to with the shield on (I've tried many times out of laziness hahaha)

For the front zerk on the front shaft maybe try pushing it on harder? there's no real trick to it. My cheapo Lucas grease gun goes right on.

 

Got dirty

 

Awesome set up you have there.

 

I took mine for a swim

 

Being an autobody mechanic, I have installed hundreds of aftermarket headlights on the job over the years. These are better quality & fit than any other that I've ever seen. Here's a few daytime pics

 

I went to replace the valve cover gasket and when I removed the air intake resonator thing (2.7 4 cylinder) I saw what what causing my oil leak. There is a small 90* hose that goes from the valve cover to the resonator, it pulled off the valve cover too easy. I ordered a new hose and squeeze clamp (you need two but the hose comes with one). The parts cost $13.

 

Spruce mica DCLB and cap to boot? Don't see that too often, ISA VERR NIICE

 

Installed a very affordable Tonneau cover. 189.99, not bad! Seals up pretty good too.

Ive wanted a roll up one for a while. Def recommend so far.

 

Where did you get it?

 

ah, here you go!

Tyger Auto T1 Soft Roll Up Truck Bed Tonneau Cover for 2005-2015 Toyota Tacoma Fleetside 6' Bed TG-BC1T9037, Black

$207 Tyger Auto T1 Soft Roll Up Truck Bed Tonneau Cover Compatible with 2005-2015 Toyota Tacoma | Fleetside 6' Bed (73") | TG-BC1T9037 , Black

https://www.amazon.com/dp/B01M1JYPWN/ref=cm_sw_r_cp_api_glt_fabc_9T2WHXQAJ4AF92R69R1M?_encoding=UTF8

they have them for every bed size and also for 3rd Gens

 

Detailed the inside of the truck. Polished the glass and 303 on everything.

 

First detail at the new house! Finally had time to clean her up before the heat wave coming in. Wash, wax, 303, full interior detail, American flag, done...

 

I have the extended one......that thing is awesome!

 

Here goes nothin