Shop Time w/T.W. Friends

That too.
Next up; I recall the former coworker mentioned before I left for AZ, uh, hey Donnie that DRO isn't repeating. (I seen him writing numbers down to see if he could figure out a correction factor) now I'll swing a indicator and get the head dialed in. I'm betting there lies the problem. I seen it when milling, and those brackets I made yesterday are wanky hole off center a bit.

 

@07RedTacoDawg Danny, haven't seen you around in a while. Hope everything is good

 

Y axis off .033" and X off about .012"
That would do it!

 

That is like a mile!

 

You'd think a 30 year toolmaker would know...

 

Akshually, it's 5.20833333e-7 and 1.89393939e-7 of a mile, respectively.

 

Mornin' folks.

 

Ya, but the e-7 parts cancel out

 

Mornin

 

Morning fellers…. Let’s have a great day doing whatever it is we do best ​

 

Don’t tell the guys screwing up that, I work hard at my job trying to get them to not do that!

 

Nice safety squints and sparks right to the kisser!

 

Well..yeah but I was wearing my prescription safety glasses minus the side shields. And yes I really would have had a face shield on if I had one. I think that I might have a weld hood with clear lens. I'll be buying a face shield for sure.

 

@Cwopinger you still alive down in Florida?

Press 1 for yes
Press 2 for dead

 

Shop time, little bit of history lesson

 

Just went through that Mind Bending exercise tryin’ to pay an invoice. Then it hung up on me.

 

Or, just grind on things where you don't kick sparks into your face?

Too bad they're owned by Saint-Gobain now... which is French.

 

Most of the time working under a vehicle that isn't possible

 

#3 hablas español?