What Have You Done To Your 3rd Gen Today?

My truck hasn't arrived yet. I've bought a few small things and picked up a couple of these.

 

Been home sick with Lyme (never even knew I'd been bit & I'm anal about checking anytime I go into fields or words but was caught early enough to be treatable w/ 3wks of doxy).

Was going stir crazy so changed the engine oil and rear diff. Front diff got off schedule w/ rear since needle bearing was replaced w/ ecgs bushing last year. Engine air filter was spotless--how is beyond me. I'd not touched it since at least last Fall. Cabin filter was another story! Pretty sure there was a whole dog stuck to it.

 

I purchased a used lietner acs rack! thanks to Tacoma world for the purchase hook up

 

Two things:

1) The red square, that's a neat little bracket dealie. Is it a canopy mount or something? I feel like I could make use of a couple...
2) The yellow square, clever idea. Consider it stolen.

 

What bed stiffeners are those? They look like they're short enough to go under the brackets for bed extender.

 

I didn't even realize the glove box had a lock until you posted this.

 

Installed bed stiffeners and OEM power tailgate lock. Both went in without issue.

 

That’s the tonneau cover brackets.
I had the two spares.
That net was an extra from a 3 pack. So I thought that spot might be good. The other two are on the doors.
Copy away bud!
Edit. The tonneau is from u-guard

 

Lol.. it's actually not too bad. Instructions are well written and easy to fellow. 2 people are recommended laying the productive vinyl decal.

 

Which version of the thread are you following? I’m kinda worried Meso will never have the lower switch panel in stock again!

 

Received my camera relocation kit plug and play. Simply unplug oem camera and plug this in. Bought this for my tire carrier which will block oem camera

 

Finally installed the tailgate lettering! It wasn't nearly as traumatic as I make most projects. I really like these ones because they're metal vs a vinyl or plastic.

 

You have a link to that PnP wire harness?

 

My favorite bed rack from a design and engineering perspective. Definitely on my list when I get to the bed. Question -- how hard was it to install? I am worried that being all thumbs I may not be able to.

What a find ...

 

I think he just had them in stock not to long ago. I just bought the overhead switch panel. All his 3d printed stuff are limited runs only. It’s not often and when they do come out they sell fast. So just keep your eyes peeled.

 

Installed my front suspension. Now sitting at 22” all around.

 

Installed the Rek Gen mud flaps. I’m really liking the red and black scheme.

 

Added this two piston air compressor to the bed of my truck and secured it with an adjustable master lock to the D-Ring. Super quiet and runs perfectly off the trucks 110v power outlet.

 

https://tailgatecamera.com/

 

I’m assuming this kit?

https://tailgatecamera.com/products...em-wiring-harness?_pos=6&_sid=df6f3cb5b&_ss=r