Shop Time w/T.W. Friends. Rusty's art poll, see post #89179 and vote now for awesomeness.

I kind of split the difference and got a pair of Rockport Elkharts - dressy enough to wear with dress pants but aren't oxfords.



They're listed as snow boots but I have no idea why because they aren't insulated.

 

My task for the day, make ten of these. Oh, I got 3 hours

 

Shane
People with a name other than Shane

 

Let me guess, stainless?

 

Lol, no fortunately aluminum.
Oh god no, no stainless

 

It's just a plug for the bottom of a moisture separator/filter. At some point I think someone gorilla'd one, broke the factory plastic plug, so here we are

 

Shew, that was close

 

I wish they would give us an allowance for work shoes/boots. They provide us FR pants, FR long sleeves, and cotton shirts, but no shoes? I always buy the sneaker steel toe and electrical hazard type. I can't wear boots, too much chaffing for me.

Speaking of the FR pants, I swear Cintas is starching them damn things, and they still come wrinkled! It sounds weird but I have to iron them most of the times...

 

With Cintas here I can stand my uniforms up in the corner from so much starch.....

 

I had 3 torn shirts I turned in; they replaced them with shirt that were possibly made out of oak.....I miss my torn shirts.

 

27/32????? Really? It would have made that much difference going down to 3/4?????

 

Our cotton shirts are up to us to wash oddly enough. Because yanno fabric softener effects them, find it kinda odd. The button up shirts that Cintas wash, yea they're stiff as Hell. They want us to weld with those on, but I've burned several up... They might work for arc flash, but apparently not stick welding.

 

I don't see where that would have made any difference at all. The Engineers who signed off on it were very new then and my guess is they measured a factory plug and went closest fraction on the chart.
Daye on drawing was from 2006 so I must have done these before. Kind of foggy...

 

Yeah, the button shirts are rough; I'm sticking with my old soft shirts.

 

Morning Shane, Hope you are well

 

4.5 hours in and got 1 turned, better put phone down and get busy. 10 in 3 hours...planners just throw a number on there
Single pointed threads until a nut would just start then used a die nut so didn't come out loose. Then slightly undercut so the nut would shoulder.

 

Doing good Bill, hope you are

 

Yesterday I saw a grey fox run across the back parking lot. Where is the grey fox this morning?

I’m not sure if this is mom or dad bowing up on me

 

This must have read my lips when I said “I’ve got 7 shots”