What Have You Done To Your 3rd Gen Today?

Sorry to hear that. Do you have any sense as to why these needed to be replaced? Luck of the draw? Hit a few potholes? Heavy off roading? I would be curious what you think may have been the cause.

Of course, I wish it didn't happen at all ...

 

Wash/waxed/buffed out some scratches today.

also confirmed the vinyl film over the nose and the mudflaps were not OEM. Thanks previous owner person!

 

What LEDs did you use? Looks good

 

Took her out good

 

Yeah I've got avid front, sides, and rear!

Not the best for heavy off roading, but still good for light trails! The geometry of the rear guard actually helped save my rear bumper on a steep incline.

Tbh, I think my skid has seen more action than the front guard!

 

Taking her fishing

 

Nice lookin' truck!

 

Yes. I wanted full bed access instead of 2/3rd access so I narrowed my choices to Undercover and Bakflip. One thing to consider if you have a preference is that when the last section of the Undercover is opened is stands vertically compared to the Bakflip that leans against the back of the cab.

I have a friend that has had an Undercover on his F-150 for 9 years with no issues so I was leaning that way then I found a 20% discount during Amazon Prime day so that was the final decision for me. The installation was quick and easy too. I just need to pick up a couple more fittings today to run the drain lines out of the existing bed drain holes and I will be done.

 

NICE! What Rpod is that?

We pulled this up to Fort Mountain, GA. Sumo Springs. What made you go with air bags?:

 

Love how this Baja Designs 20" light bar has amber running lights, the sliders are Apex. Both installed yesterday.

 

Lomax now makes a cover that folds up the last 3rd as well.

 

New shoes fit well! More of a difference than I imagined. Discount Tire did a great job getting me in and out in less than an Hour!

 

20 foot? Typo?

 

This is why I should spell things out lol

 

Was wondering if any one has done something for this. I know it is anal, but that is how I roll....

Looking for any thoughts or things others have done to prevent rock chips from rusting so it doesn't look like total crap until it is bad enough to remove and have them re-powder coated?

 

Aren't those aluminum? I don't think they'll rust.

 

And a gentle dab of some flat black rustoleum on a sponge or foam blush should hide any chips or scratches.

 

Me too, tomorrow!

 

I have the same floor mats. They are great. Sold my oem all weather for 60 local

 

Doh! never even thought to check actually. regardless want to touch them up, had considered rustoleum or possibly even some flex seal on the faces. Maybe it would help prevent additional chips. Was curious if others had tried something with success.

Appreciate the replies!