Does your lifted Tacoma fit into the garage?

Going to lift my new 2011 DC but I still want to be able to park in my garage.

Does your lifted Taco fit into your garage?

I have a standard attached 2 car garage with the standard 7 foot high door.

Wondering how high I can go before it wont fit?

 

i have the same thing 7ft garage and i have 2.5 billies on the front with a .5" spacer so about 3" in the front and an aal w/ 1.5" block in the back... sitting on 33" toyo open country m/t's

fits fine....

 

You could always lift the garage.

 

yup. lifted longbed...and my garage takes every inch of it, like she should.

 

I'm betting a 6 inch lift would not make it.

 

probablly not so much....

 

Yea 6" lift or 3" lift with roof rack is pretty much out of the question. One thing to note is that depending on what kind of garage door you have, it may or may not fit. The garage door that rolls up creates more room as oppose to a garage that just goes up (hard to explain)

 

2.5" lift here and mine fits. I have about 6 inches to spare. I also adjusted the up-travel of my garage door so that is pulls up in the the garage even with the header. There should be two travel adjustment dials on your opener that you can adjust to have it pull up further if you need more clearance.

I will let you know in the spring when I put the OEM roof rack on if it still fits.

 

one peice doors v.s. roll up
-true

 

my friends 6" lifted silverado on 35's fit in his garage, so im sure a 6" lifted Tacoma will.

 

7.5" and i fit

 

Lol...yeah in the bay doors of the firehouse!!

I got a 3" lift with 33"s and used to have a Yakima roof rack and I still fit.

 

Mine fits top to bottom...but with my bike and my work bench it's REALLY close front to back....

 

6" lift and 35"s, no problem fitting.

 

I'm thinking you can go all the up to 6'11"... jk

I am lifted 2.5" and fit but I had to cut the excess off of the bracket that ties my garage door into the opener. The bracket is kinda universal and has many holes so you match up a set of two and run nuts/bolts through them. With my setup, I had about 6" of excess bracket hanging down that I cut off with my sawz-all.

 

Haha here's my fitment front to back.

 

yup i have a 6" procomp lift with 35" tires and mine fits fine

 

Only with a full tank of gas and the little knobs on the kayak stackers turned to be horizontal. And then I have 2mm of clearance.

 

I fit by height but not length. Its like an Anaconda in a green bean can.

 

Mine is so close to the door that when I back out or Drive in the antenna pings the bottom of the door (and the antenna is about an inch higher than the top of my truck. anything more than a 3 inch lift would not work in alot of places (including parking buildings, etc...