What Have You Done To Your 3rd Gen Today?

I drilled through mine and was then able to use an easy out. But a machine or fabrication shop would be your best bet.

 

Night run

 

If I remember it’s kinda hidden by or near the plastic box/cover located nearby

 

Thank you, My thoughts are with you

 

Thank you… you as well

 

May I ask where you got these strips?

 

TufSkinz sells them. I have some AG due to be delivered any day now. https://www.tufskinz.com/collection...034-strip-above-climate-control-toyota-tacoma

 

Love the look of the tires with no lift. You mentioned hammering the pinch weld but did you do a CMC? I'm currently planning on 285/70/17 with no lift so I'm curious what I'm gonna have to cut

 

I’m not the person you asked but I’ve done it for buddies of mine. Depending on the brand of tire. Front viper cut, cut some plastic off on the rear of the wheel well, cmc and pinch weld. You can probably get away with less but if you wheel you need as much space as possible

 

Put a check in the mail this morning for $16K. Payoff, 15 months from when I bought her new.

 

Where did you get these decals?

 

I'm getting my 2021 tuned on Friday.

 

Good ol' Shay Laren there guy lol

 

Installed oem air flow accelerator with K and N filter.anyone have any recommendations on where to get good touch-up paint for MGM color? Have a few rock dings wanted to fill in before rust gets there first

 

The best mod

 

MJE_Tacoma is correct. If you want to run 285s without a lift, you'll need to do the pinch weld, CMC, remove some plastic/fender liner and a front viper cut. I will say that if you plan to take the truck off-roading, I would be mindful what lines you take cause you will rub.

I have lifted the truck since that picture so I have not done my cmc yet (also, because I'm kinda tired of working on the truck since I did a lot of work in the past 2 months). I didn't want to do the front viper cut since I want to sell the front bumper when I get my high clearance bumper. I will get to it eventually but I'm holding off since I'm trying to learn how to weld and want to weld a plate the same time I do the chop.

 

I really dig that! Very cool

 

Continuation of my last 3 posts. Photo heavy...again

Early/Mid June - Finally got my Rago Fabrication center console molle (still no cb antenna mount, delayed). 6 front runner quick release awning mounts, front runner wind fairing, pelican vault for recovery gear, front runner traction board mounts, maxtrax. Also added rear work lights/chase lights to my diamondback cover (with quick disconnect near the front of the bed when I take off the diamondback), changed the clear lens on the squadron sports to amber

Before - with radio connections on passenger side

Driver side w/

$65 uniden pro520xl pro series 40-channel CB radio. compact design. ANL switch and PA/CB switch. 7 watts of audio output and instant emergency channel 9. - black

uniden pro520xl cb radio

Passenger side w/ midland micromobile gmrs radio


Front runner quick release awning mounts (did 3 on each side, passenger is for awning, driver for privacy tent/shower room, but since there are 3 on each side, I can use both side for either one).


Wind fairing, pelican vault, traction board mount and maxtrax


Rear work lights/chase lights

In chase light orientation (need to tint yellow/amber)

In work light orientation


Changed the squadron sport lens to amber


switch pro button layout

 

I saw they had some toyota paint at O'Reillys in florida. Had some for my paint color. Check online, or Toyota or other auto part stores

 

Congrats!