What Have You Done To Your 3rd Gen Today?

New decal to remember my Dad who passed after a 5-month battle with pancreatic cancer, love you Dad

 

Looks like you got a little golf action in today as well

 

Glad you’re back mister.

 

Removal was not too bad. I cut the rivet heads into crosses and used my air chisel to cut the heads off (If you don't cut the crosses it will take a bit longer and eat up the edge of the chisel).
I used a flapper wheel to grind the heads flush to the frame and then used a ball joint press (C-Clamp like) to push the remaining part of the rivets out. Step bit was used to open the holes up to the proper diameter.
Maybe an hour per side. Worst part was me working on the ground (50 years old LOL).

 

Nice tribute. Lost my Mom last year. I will always remember her and truly feel she lives on in her children and positive influence on so many lives. Sending love and blessings to you and your family.

 

Mobtown Offroad rock sliders managed to get on the truck today. Extremely long lead time and out-of-date installation instructions considered, I'm still satisfied overall. They're a great design.

 

Did the airflow cyclone and then noticed i missed a milestone by 2 (3 yrs come sept)

 

they came with this particular grill:
https://mcautoparts.com/products/3rd-gen-tacoma-grill-kit?variant=31475975356478

 

Took me two days:
- Tinted my scene/work lights yellow (to attract less bugs at night)
- Tinted factory LED Fogs to yellow (no photo)
- Installed second battery w/ off-grid engineering battery trays, RedArc BCDC, and X2 Power Group 35 AGM Deep Cycle Battery






Can finally run my dometic fridge without worrying about my starter battery

 

DIY Spare tire bed mount install is up on the channel.

https://youtu.be/JQB3uIFhPac

 

Here a pic of side bar

 

That looks good and tight. Which kit did you use?

 

I pulled my rear seats out and installed some Kilmat and then the Goose Gear seat delete. Also added the Snapsafe head rest gun rack hooks.

 

Anyone have any rattle issues with their wireless charging pad? The thin trim piece on the side of the pad closest to the cup holders is flimsy and rattles and drives me nuts!

 

Added the RCI Full Skip package today. Raw aluminum.

 

You gotta get one of these next

Brand: ESI

$36 ESI ROK BLOCK Tailgate Gap Cover 4.25" width

4.4 out of 5 stars 457Reviews
ESI ROK BLOCK Tailgate Gap Cover 4.25" width

With my diamondback on its hard to close because of the seal. Still not fully waterproof, but keeps the dust out

 

There is a tsb.
https://www.tacomaworld.com/threads/qi-pad-tsb.702716/

 

mine isn’t bubbling, it’s just the small plastic piece where the pad meets the cup holder assembly.

 

Nothing a little heat gun can't cause/fix - instant bubbling

 

Haha.