What Have You Done To Your 3rd Gen Today?

Did the airflow cyclone and then noticed i missed a milestone by 2 (3 yrs come sept)

 

they came with this particular grill:
https://mcautoparts.com/products/3rd-gen-tacoma-grill-kit?variant=31475975356478

 

Took me two days:
- Tinted my scene/work lights yellow (to attract less bugs at night)
- Tinted factory LED Fogs to yellow (no photo)
- Installed second battery w/ off-grid engineering battery trays, RedArc BCDC, and X2 Power Group 35 AGM Deep Cycle Battery






Can finally run my dometic fridge without worrying about my starter battery

 

DIY Spare tire bed mount install is up on the channel.

https://youtu.be/JQB3uIFhPac

 

Here a pic of side bar

 

That looks good and tight. Which kit did you use?

 

I pulled my rear seats out and installed some Kilmat and then the Goose Gear seat delete. Also added the Snapsafe head rest gun rack hooks.

 

Anyone have any rattle issues with their wireless charging pad? The thin trim piece on the side of the pad closest to the cup holders is flimsy and rattles and drives me nuts!

 

Added the RCI Full Skip package today. Raw aluminum.

 

You gotta get one of these next

Brand: ESI

$36 ESI ROK BLOCK Tailgate Gap Cover 4.25" width

4.4 out of 5 stars 457Reviews
ESI ROK BLOCK Tailgate Gap Cover 4.25" width

With my diamondback on its hard to close because of the seal. Still not fully waterproof, but keeps the dust out

 

There is a tsb.
https://www.tacomaworld.com/threads/qi-pad-tsb.702716/

 

mine isn’t bubbling, it’s just the small plastic piece where the pad meets the cup holder assembly.

 

Nothing a little heat gun can't cause/fix - instant bubbling

 

Haha.

 

I did 2 coats of Bulldog, then 2 coats of black, then clear and then plastidip… a little overkill but didn’t want to have to do it again

 

Do the front/rear tint looks similar from inside the cabin? I've been seeing a few of you with tint and getting an itch to have it done too...

 

I was worried about it too before i got mine. I had it for awhile now. Its just right, i got the white. One did come with a broken clip on the housing, i got it replaces eventually but it was kind of a pita to get response back from the seller.

 

Great addition, works well. I had to trim slightly for the Sabellco lock but I think that it came out well.

 

No UCA and no CMC. Just had to trim a little plastic off the fender flares.

 

Not the guy you replyed to, but do it asap. And do it right, get ceramic tint. I went with 20% all around, so rear is a bit darker cause of factory tint. But they look similar from the inside. Obviously you notice the back is a tad darker, but it's subtle and not something that jumps out to you. I can try and get an inside pic for you if that would help?