What Have You Done To Your 3rd Gen Today?

Did Katzkin too and when I thought of saving the cloth I called the shop and they said they already cut it up taking it off. Not sure bout your installer, but if you want to save it you might want to check before they start.

 

No sir! They are OEM Toyota, so they bolt up perfectly.

 

Wrapped up my 4XInnovations mini bumper install last weekend. Went pretty smoothly for having no instructions!

 

Hasty paint job and a few bolts later... my 110v is out of the way and clears the Decked drawers.

 

Put on some vinyl overlays on my stock wheels this weekend.

 

I bought a set of oem also. Tire shop wouldn’t even put lugs on them. Said they fit to tight. Been researching on here. Seems to be an issue although rare. Just my luck though.

 

Man that sucks...
Do you know if they just tried one wheel on one hub and it was too tight so they didn't proceed?
Or did they try all 4 wheels on each individual hub to hopefully narrow down the issue?

 

Tried 2 wheels on the driver side. Both were so tight they struggled to get them off. I just don’t understand the issue. Wouldn’t lugs pull them being a little to tight is bad? I’m gonna try another place before I give up and try to sell these wheels or trade them maybe. I’ve seen dozens and dozens of trucks with these wheels on here.

 

Does that stick out less than the stock plastic? I have been toying with getting something similar.

 

Check the drain hose. It can be pushed back into where the condensation collects causing the condensation level to build up until it reaches the top of the drain hose before it starts to drain out. Just give the drain hose a gentle tug to see if it slips out a little. I found this out when I did the A/C drain mod.

 

This is the way my 2020 works as well. Very annoying as I prefer to run the AC without recirc on unless I need MAX cooling. I just got to figure out why it is leaking inside after running a while. I think the area that holds the condensate inside gets full and can't drain quick enough.

 

I would have the new shop try mounting

I would have the new shop try mounting them on all four corners. It could be possible the issue is just your drivers side hub.

 

I wasn’t 100% sure, but yes it sticks out less, besides the shackle mounts, which are probably about as far out as the stock plastic lip.



I have it written up here if you, or anyone else is interested.

https://www.tacomaworld.com/threads...ont-bumper-install-with-pictures-2016.727736/

 

Do you have a link for these?

 

https://www.etsy.com/listing/811564144/toyota-tacoma-2020-2021-trd-sport-wheel?ref=yr_purchases

Can't speak for how long they will last as I just put them on, but they went on well using the wet method. Also, the seller gives you enough for 5 wheels incase you mess one up and they were all cut well.

 

If someone’s buys it it’s worth something. Just list it on the bts forum ask for whatever you feel is good and be willing to flex.

 

My want to confer with others about that switch. I don't know how much it has to do with the leak, but it seems to me it should function as I described, and that turning on your AC at any temp below the max setting should not trun on recirc.

 

Same thing happened to a friend of mine. And her truck is outside the warranty period. eBAY for the win on the new part, because Toyota apparently wants some outrageous money to fix the problem. A few people have done some interesting shrinking by heating/cooling the pad.
Either that, or I think I've read that some people are removing that charger and putting something more useful in the space.

 

Do you by any chance have the old one? Someone backed into me and broke a few clips of mine…

 

Got a wider shot of that?