What have you done to your Tacoma today? 1st Gen Edition

Yep, parts wise anyway. Might want to consider replacing the rubber dust boot that goes around the LBJ boot if it's torn up (only on 01 - 04s).

 

I pulled it out and reinstalled it and it seems to have gone away. I think there may have been a little corrosion in the plug.

 

Just ordered mine as well

 

Now which pins on a 99 do I need to jump out for the SRS system to read the codes. Its different than my 04.

 

Ping me in a few hours to remind me o look it up if no one answers. I can pull up TIS when I’m home

 

@Reh5108 Jumpers are on the DLC1 connector. should be under the hood. labels are under the cap

 

Appreciate it!

 

A couple days ago I had the center bearing replaced on the rear driveshaft. Today I changed plugs, wires, pcv valve, and greased the front driveshaft/u-joints. Heading out on the beach again tomorrow.

 

finished my front rear and side camera switch. Added a monitor at eye level. Monitor will automatically display front and rear as you shift reverse and back to drive. You can also turn on front with a switch. Right side camera has its on switch and will only display on the top monitor. This way you can see both forward and side or reverse and side. See images for demonstration.

and added a project name tag inside

 

Very nice

 

Another 10k Mile balance and rotation at 670,000

 

Did the dealer have a new belt?

 

I bought a new one but they are running out depending on the color u have

 

Powder Coated, Chassis Unlimited Winch Bumper Ordered 5/29/2021. Received 7/15/2021

 

picked one up on eBay.

 

Had to do some cleaning and rearranging of my shelf. Dug out some parts to get sent off for the boys 4runner.

Going to send in the throttle body in for a rebuild and we'll get the TB spacer port matched.
Had to fix this guy the other day. It broke last time I was out. Luckily part of the u-bolt held and I was able to tie a strap around it to keep it tight. Might need to find a different latching method.

I finally reinstalled my fender flares. I tryed to get a bunch of sealant around the snorkel connections before I put the liner back on.

I think I need to pull the fender to get the top.
I also started to change out the fender screws for a flat heads

 

Guess I didn't do a very good job of sealing my diff up when I swapped out 3rd member

 

Chassis Unlimited Bumper arrived. Very impressive Craftsmanship and Powder Coating.

 

Gathered all the parts I thought could be the problem of a mysteries no code misfire. Then today with 216,000 miles on my truck, (2nd owner) we changed out the Coil Packs, the Plugs, the plug wires, the Fuel filter and all 6 Injectors. Replaced vacuum lines and anything that looked like it needed it.
All good now. Ripped it down the freeway onramp and didn't miss a beat..Beer 30

 

I like this bumper. Do you happen to know its weight?