1st Gen Lunchtable Thread - General Discussion

That is so fucking cool

 

A degen from upcountry

 

@Wulf @Kwikvette https://www.instagram.com/p/CRWnhTyrM5u/

 

And...there's a multiplayer online mode

 

Oh yeah. That’ll do it.

 

Anyone have a spare axle?

https://www.instagram.com/p/CROoJZCpHcw/

 

@Sperrunner

 

@eon_blue Good Photoshop skills, young child... Is this you?
https://www.instagram.com/p/CRZvB6pB1Q7/

 

You trying to go on a romantic spiny axle ride with me?

 

You need more trucks

 

Morning all. Going to be ordering the new meats next week finally, but found they no longer sell the hankooks.


Looks like I'll be going with the Mt g003s instead. @m3bassman @chrslefty apologies if it's been asked before, but what treadwear are u both getting so far? I know @chrslefty had some lug chunking from the rocks here in az.

 

Still have the chunks. Aside frome a little rough around the edges there wearing well. You can come over and see them if you want. I'm in mesa. I still think there a great tire. There's a guy in the az classifieds selling a set super cheapish.

 

Got out after breakfast.
It was all going so well...took about 30-45 minutes total to press in the bushings, get the old shocks off and put the new ones on.
Snugged up, I set the torque wrench, and on the third bolt, snap!
FML


Now I have to figure this out




P.S. If anyone doesn't have a vice or is too lazy to get theirs to re-setup (hello) this worked perfectly, popped right in. Couple scraps of wood and my OTC clamp/bolt.

 

"If the wonen don't find you handsome at least they'll find you handy."
Red Green.
Very Clever

 

Wow.

Sorry to hear, that sucks.

 

Guess it just wanted to go.
I'm hoping I can extract it.
Supposed to drive it for a shop appointment Monday morning haha
I have some easy outs but never needed/tried em...

 

Fortunately you can drive without rear shocks.

It'll just be a bumpy ride for the short drive there.

 

True, but the appointment also included my state inspection lol

 

That bolt should extract easily, it's a fine thread, just drill a good bit out of the center to relieve the tension and use and extractor with some heat if you can get access to a propane or MAP torch

 

I pressed my bushings in with a vice haha


And then put them under my bed where they’ve stayed