Ontario BS Thread

It's all about the wheel base....shame on you for conjuring up this...

 

I had bought a couple of those and they wouldn't quick charge .

 

You bought this specific brand? They quick charge my phone. Hmm maybe I should try charging my jump pack with it.

 

No, I bought the cheap ones from variety stores that were advertised as quick charge.

 

He said when he turned the front cam it was flattering out the tab.

 

So I guess I wasted $136 on an alignment, and I’m going to have to do it myself after all. How accurate can I get it with a string and a measuring tape?

 

@jordi992

 

Shouldn't happen if you jack up the truck by the frame to take the weight off. This trips up some shops because you need the truck on wheels to take measurements, but on jacks to make adjustments. Most roll-on lifts have a frame jack in the middle that requires hooking up an air hose, very slow, etc., and time is money in the shop.

Depends on your setup. You want a flat, level concrete floor. Get steel plates about 1 sq ft and grease the bottom to act as turn plates. You'll also need a digital level to measure camber. With a good setup you can get toe within 0.1 deg and camber to the accuracy of your gauge.

 

You the man! I'm gonna send a message over rn

 

Never mind, they don't fit an access cab

 

Wut? DCSB sliders will fit ACLB. They're effectively the same frame. This was discussed here literally in just the previous page.

The design is kinda wonky with the missing closeout tube at the rear end, but that's easy to fix with a hole saw and welder.

 

Government of Canada has a 2nd gen for sale. Looks pretty rough.

 

ACLB is the same as DCSB. It’s the DCLB that has a completely different frame. Those sliders will fit

 

Do what @3JOH22A wrote. Hardly ever is he wrong about our trucks ( I think that's correct language wise )

 

Agreed, the only question is my lack of skill executing his instructions.

 

I didn't even know this website existed

 

Think the lug pattern matches our trucks? https://www.gcsurplus.ca/mn-eng.cfm...type=&lci=&str=1&lotnf=1&frmsr=1&sf=ferm-clos

 

700 bucks? Seriously, if this thing goes for under 3k it's a steal....

 

Well it's an auction that started 4 days ago at $250. It's at $760 now and has 3 days remaining. Probably a lot of last-minute sniping bids like everything else.

EDIT: what is this?