Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

Harry is here for his social media skills. If left to Jesse the snowflakes and rust belt peeps would be crying in the corner.

 

Oh lawd

 

Exactly... I actually don’t even do any fabrication. I am however excellent on social media and putting my $150k liberal arts degree to good use

 

can always go back and get a masters in *communication*. plenty of work-experience dealing with all of us forum kindergarten idiots.

 

I didn't know a degree in underwater basket weaving cost so much now a days.

 

Cant wait to see the finished product.

 

Hey I have one of those too. It was a good time though…

 

Did yall see there's Portal Hubs out for the Tacoma now from 'Werewolf4x4' on instagram I think was the name? Popped on my feed this morning. Should've grabbed a picture. Though it sounds like it'd be cheaper to adapt something else to fit since they say the full kit with hubs, portals, shafts, brakes etc was $14000.

Supposed to be bolt in for the toyota IFS 05+ and rears

 

I kid you not, I had a supervisor when I worked for Midway USA who's BA degree was in pottery. Very relevant to supervising a firearm parts retailer.

 

Yep that's what popped up for me too. Portal hubs sound cool, but not $14k cool. Now if they mean 14k Ukrainian hryvnia then I might consider it since that's like $520 usd.

 

Officially got the ball rolling on the front and rear LT. Now for the 9 month wait….

 

You should of stayed there

 

hmm $12/hr vs $34/hr... yeah, no.

 

Fair enough hahaha

 

Though getting my AR built for half price was nice.

 

Right

 

That's not bad, 3k per hub is about the going rate last I saw, and those weren't bolt on.

 

@81Trekker what kind of long term maintenance are we looking at for the 934s? Boots won’t be hard of course, but how difficult would it be to replace/source the joints when they wear out?

 

For me it's just not something I could afford to do right now or in the near future.