What Have You Done To Your 3rd Gen Today?

I’ve been looking into this mod as well. Just not in the budget.

 

Mine came with two foam squares with adhesive on one side. Just took the front rail off, attached them to both sides, and now there is no front gap in the corners.

 

LED dome, vanity mirrors, & maplights. 30 min install. 5min to switch to the LEDs, 25min to look for 1 maplight bulb that fell into the black hole between the drivers seat and console.

 

I installed a carrier bearing drop during my lift. After removing it, the vibes were less. I think my only vibration now is my needle bearing, so I’ll be installing an ECGS bushing as soon as I can find the time

 

How big of a lift? I was under the assumption that if your 2 inches or under, you should be ok.

 

I might have installed that foam wrong. I can still see “light” thru that corner.

 

I think you can just put electrical tape over the "low fuel" dash light. It works for the "check engine" light so its got to work for that too right?

 

I'll gladly pay shipping for the OEM bulbs.

 

Installed the front bed rail (thank you @CorpsTaco ) and some tie downs, installed new air filter, cleaned bed and bed mat and changed the oil/filter. Last time it was done at dealership and I swear they used an impact set to infinity. Used the filter wrench with slots and a damn near a breaker bar to remove it. Need to get the aluminum housing and ditch the plastic one.

 

Sound good, pm me your address and I'll try to get it out this weekend!

 

I’m up about 2.5”. OME 888 springs on lowest setting of 5100s with medium dekars in the rear

 

On my own tomorrow

 

went and looked at it. Arrived at the dealership today. paperwork on their end needs to get all finalized. Go get it tomorrow if all goes well.

 

Magmounts for everything. Usb c cable pulls out when needed and slides back in when not

https://www.amazon.ca/dp/B0843912JH?ref=ppx_pop_mob_ap_share

 

I admire your ingenuity, but I could never do that (USB Cable in dash) to my Taco. lol.

 

Installed the new Tacobar from Bulletpoint mounting solutions just now.

 

My Ram XL phone mount and ESI tailgate seal came in yesterday from our favorite place: Amazon. Phone mount got put on this afternoon before work. Tailgate seal a job for this weekend.

 

Prinsu Top Rack

 

My wife loves her Bronco Sport. It’s pretty capable as well.

 

Well I caved and took out the boxes in my Trail Edition. I was going to put a hard cover on for a trip next week and decided I wanted the extra room. Plus they're pretty worthless as they leak like crazy.

Going to keep them in case I want to reinstall them at some point.