99 2.7 4x4 part out. photo updated 9/18/21

Just picked up this guy, it was in a head on and then went up on its side. motor was still running after the hit and than was turned off.
Interior is grey.
There are no spindles hubs axles or rear axle.
Located Near Lake Tahoe CA/NV I can ship on buyers dime. I also have a lot of leftover parts from other trucks.

Toyota Tacoma 3rz block and head - $500 SOLD

Toyota Tacoma Throttle body - $100 SOLD

Toyota Tacoma W59 Manual transmission - $300

Toyota Tacoma Engine Harness - $100

Toyota Tacoma Under Hood Fuse Box - $100

Toyota Tacoma Intake Manifold -$40

Toyota Tacoma j-shift transfer case - $250 SOLD

Toyota Tacoma gas tank skid plate - $100

Toyota Tacoma regular cab carpet grey- $100

Toyota Tacoma Full cab harness $200

Toyota Tacoma Grey interior parts prices very

Toyota Tacoma Sun visors Each $20

Toyota Tacoma Door Panels Each $50 PENDING

Toyota Tacoma 4x4 front diff 4:30 gears - $250

Toyota Tacoma Manual diff tube $100 SOLD

Toyota Tacoma steering rack - 4x4 / prerunner $100

Toyota Tacoma bed green - $300

Toyota Tacoma Air Bags passenger- $100

Toyota Tacoma gas fuel tank - $100

Toyota Tacoma 4runner 4wd 4x4 J shift transfer case - $200 SOLD

Toyota Tacoma Drive shaft 4wd front Reg cab - $80

Toyota Tacoma frame cross members each - $60

Toyota Tacoma Lower control arms - $100 SOLD

Toyota Tacoma upper control arms- $40

 

How much for the T-case shift knob shipped to 80918?

 

4:30 gears you say… damnit that’s tempting for the tundra.

 

Is the black bezel that goes around the radio and center ac vents damaged in anyway? If not, how much shipped to 31645?

 

Would be interested in the driver side door the part where you lock the door that trim panel only if its not damaged.

By any chance in thise bucket seats on the driver side do you have the plastic part on the bottom of the seat where you adjust the seat.

Also do you have the transmission mount? Thx

 

Sir, I'll take the w59 transmission and the 3rz motor.

Let me know if you'd like me to PM you. I'd do local pickup.

My current transmission is pretty roasted from oiling issues and I am looking to build a 3rz as well!

 

OUCH! Never mind... Never been to Tahoe yet, but thought it was only a few hours away. It's over 7 hours and that's without traffic. Sorry for the bother!

 

I am looking for the shifter bezel with cup holder on the side- got one?

 

I'll go pull trim on my 99 to compare the srs airbag module part numbers.

 

It's an easy drive, and seanic on 395. Takes me about 7 hours to get down to my parents house in riverside. If I head down in the next month I'll bring it with me.

 

Sorry I do not

 

sorry to bother but I didnt know such cup holder existed, would it fit my 97? if so whats the part number on it? thx

 

Still have the j shift T case?

 

I'd be down for a drive like that once I get my supercharger on (still waiting on LC Engineering to ship...) for a scenic run and an adventure. But currently any extended driving is pretty brutal with a 4 cylinder and 38" tires and a mild slope at speed on the highway.

Within the next few weeks if I get all set up, I'd be down for a trip if you still have it. If you do have it on your way down I am down for that as well, but please don't let me hold you back from letting it go sooner if someone else comes your way!

 

Do you have the driver side seat belt and seat?

 

Are you willing to part:
Need the Bed Pan cross member seat supports. Both sides. The ones that support the front seats, the front bucket seat legs, bolt into them. Not sure if you can pry them off. without thrashing them.
I think its just a heavy Tac weld.? I have a 95.5 Taco both of mind are smashed, and striped out. If not, that's Kool............

 

Pm sent

 

I would like the fuel door lock assembly if the black plastic piece that locks the door isn't busted. Cant see from the pick but it might be. Would pay to ship to 74820. Thanks Edit: PM Sent

 

How much driver door arm rest?

 

Truck is fully stripped. and here are more pictures