New Front Door Speakers in 2013 do not fit...

My stock speakers finally went out, so I bought some new ones. I took the door panel off and the new speakers do not fit. The stock speakers have a plastic mounting plate that screws into the door and the tweeters are attached to a metal piece that screws into the door...
How do I mount the new speakers?! Here's the new speakers

 

My speakers were 6x7’s.

 

Here's the stock speakers/tweeters. The tweeters are connected to the metal bracket.

 

you just need to buy the adapter rings or make your own. take a look at any audio web site and they will sell the adapters

 

You needs the adapter plates in the front and back
2002-2011 Camry & 2005-2015 Tacoma Front Door Speaker Adapter Spacer Rings - SAK010_691-1 Pair

$42 Front Door Speaker Adapter Spacer Rings Fits 2002-2011 Camry & 2005-2015 Tacoma- SAK010_691-1 Pair

https://www.amazon.com/dp/B016YS6V2M

 

Here's the hole for the bottom speaker, but there's nothing to mount the new speaker to...

 

You need to buy adapters.

 

slow down and read the replies, you’ve already been given the answer

 

What about the Tweeters?! how do they mount?!

 

Thank you

 

Thanks, I just ordered these... What do I need for the tweeters?

 

pro tip - google is your friend :

https://*********.com/shop/speaker-...eeter-mounts-tweeter-installation-adapters-2/

 

I almost ordered the tweeter adapter, but there's different sizes... and then there's the plug adapters for the speakers and tweeters. lots of different sizes for those as well...

 

bro slow dow you gotta’ learn to figure this stuff out it’s not rocket science… open the tweeters and look for a template or read the instructions and see if a mounting hole size is listed or if you can just measure the template

 

Just bought these adapters... not sure if they're the right size... can anyone verify? 2013 TRD Sport front door lower speakers and upper tweeters. no speakers in the back access cab area.

 

Yeah u need the adapters for the 6x9 speakers

The 2 3/4 speakers are incorrect. You need tweeters and a crossover to work with your 6x9 speaker in the frontyour Rear doors can use 6.5 speakers. I recommend a coaxial speaker 2 way or 3 way on the rear passenger doors so that they can deliver the full range of sound in the rear

 

Tacoma World has an audio forum .The information in that forum is epic .
https://www.tacomaworld.com/threads/diy-basic-speaker-upgrade-2nd-gen-access-cab.3198/

 

For my tweeters I just cut the harness off the factory ones and connected to the new ones.

 

What size are the upper door tweeters? I have a 2013 Tacoma and want to do a complete door speaker replacement. I found some supposedly "plug and play" speakers on Amazon with a sensitivity of 98db which is a bit high to match with the 90-92db 6x9s I want to match them with.

EDIT: I should Add that Crutchfield has mostly 3/4" to 1 1/4" tweeters for this location (with modification) but also lists a set of 2 3/4" midrange speakers, so I'm a bit confused.

 

Same.

Used a piece of aluminum as a bracket to bolt to the stock location with a pair of these and it came out quite nice.

$34 Pioneer TST110 TS-T110 7/8" Component Tweeter

https://www.amazon.com/Pioneer-TS-T...00NF5EQK2,B009MS7DGK,B07GZ651HM&srpt=SPEAKERS

OP. Slow down, do some research.