What have you done to your Tacoma today? 1st Gen Edition

Omg wtf. How did you guys torque this solo?!!
I don't have a strong enough vice lol

 

I left it on the truck all the times I’ve done it

 

Left mine on the truck, too. Used an impact to tighten then backed off to *edit* 54 ft/lbs or whatever it is. Would have to double check.

Never removed the driveshaft though

 

...lol ok. I'm putting it back to torque. Impact seated it pretty good I think. Gutentight

 

54. But yeah. Guess I went a little too far haha.

 

A lot of the writeups and videos show it by removing the driveshaft so I imagine it's pretty common

 

Yeah. It was super easy till that step. I would have been cursing trying to get the rear separated from the front at the carrier under the truck. Well, not next time knowing it'll save me some time.

Thanks for the advise everyone. Super easy torqing it on the truck. Just need to stake it and torque it all down

 

Bent axle sucks. When I happens to me again, I'll probably try chromoly axles. Or maybe pull a @drr and get a complete LC rear setup.

 

What's this evidence we're looking at? I could see my tire wobble in the mirror when I bent a shaft. Or put it on jack stands, put it in gear,, and check for run out.

 

And you are sure that is gear oil leaking? Doesn't look like it. Could be brake fluid. Did you pull the drum off? @m3bassman



#thepriceyoupayfordirtyfives

 

Really easy with electric mirrors.

 

Steering rack bushing recommendations?

I am on my 3rd set of energy suspension bushings and I pulled my skids off today to find this:


These only have like 10k miles on them.

any better brands/experience anyone?

 

I bough total chaos I think

 

Edit... for some reason I thought you were asking about LCA bushings, then I re-read it and looked at the picture lol

I have Energy... and I need to replace them. If anyone has better suggestions I'd be all ears too.

 

I looked at those... They look an aweful lot like what Energy bushings would look like if they were repackaged lol

 

No idea


But I’m sure all the poly bushings LOOK the fairly similar

 

All poly bushings are actually, probably, made by the same company.

 

I had energy on my last rack, just put total chaos on, total chaos is a noticeably stiffer poly. I can’t get them to flex at all by hand

 

No idea and no care

just told the dude what I used

 

Maybe I'll try them. I've gotten a bit of use out of the Energy, but they didn't seem to last as long as I would have expected them to. Hopefully the Chaos is better