What Have You Done To Your 3rd Gen Today?

Do you have the sensor there? It's not that it won't work without the garnish, it's that it will get dirty/wet and not work properly

 

Yes, the sensor is there. Mixed reports about how well it will work without the garnish. I'll give it a try this way for awhile.

 

AC water leak saga continues.....

I did pick up the truck yesterday but was so busy with other things I did not even put my personal belongings, Glock36 and etc., in yesterday at all. Went to do it today and I find my Car Play jack is dead power and data. Plus my Amateur radio will not power up, the tap a fuse it was using must have been left off. So it goes back Monday AM.

 

Dude, you need to find another dealer, they suck!

 

You can still see the square depending on the light, but overall not too shabby. Still better than the stickers.

 

Looks pretty damn good. Yeah there's a slight "ghost" sticker but like you said, way better than the dumb stickers.

If someone wanted to make a buttload of cash they would come up with decent visor covers or a full on aftermarket visor assembly...that doesn't suck Shit I'd pay way too much money for a set.

 

Took off my hood decal because it was starting to crack and looking old. I also finally cut my bed mat to fit my 0-tracks.

 

Not to hijack the post but I installed a switch to the left of the steering wheel and ran power directly to the battery. I didn't want a switch at the back of the bed like some have done. The lights are really nice and bright.

 

I installed my PRP seat covers. I’m really impressed with the quality of their product. Took me about 2 hours to install them. I also installed heated seats for it as well. Got them off of EBay and they come with factory looking controls that fit in the dash. And sorry couldn’t figure out how to rotate the other two pics!

 

Dang!! Shade for an outdoor Livingroom.

 

looks just like the back of mine!!! Have had my 1UP for about 7 years now. Always on the truck (and previously the RAV4). I ride more int he fall and winter, and it works well in those conditions too.

that looks freaking great!!! I really got get that mod going...no more excuses

 

Mounted this today. Will have to finish the wiring another day. I had to make sure it works well as a front cam for my DMH-W4660NEX. Seems like a good quality cam. I was hoping for the rca jack to be already grounded but It wasn’t, so I have to physically use the ground wire. I’m using the red accessory +wire of the HU as a trigger wire. I’m thinking of routing the cable in one of the rubber boot in the passenger side firewall…any good advice where to route it? Thanks!

NATIKA 720P Backup/Front View Camera, IP69K Waterproof Starlight Night Vision High Definition and Super Wide Angle Reverse Rear View Backup Camera for Cars Jeep Trucks SUV RV Van

https://www.amazon.com/gp/aw/d/B078ZZSKQ2?ref=ppx_pop_mob_b_asin_title

 

These are the ones that I am going to get. There is a really good Youtube on the quality and the install here, for those that are interested:
https://www.youtube.com/watch?v=rXh78z4L754

Question for you, if you don't mind. Were the ones that you ordered compatible with the side air bags? I was waiting to order mine until the new version came out that was side airbag compatible. I called PRP and they said they were in the works ... so I was on hold.

I am looking forward to getting these ... with two dogs and a kid that thinks he is a wolf, apparently.

 

Yeah that is badd and it has the 22R motor you cant kill them things I had one in my 87 it was great

 

Do you mind me asking how much length it adds to your taco … I need a hitch mount rack, but I’m pretty limited in addition space in the garage. Sigh

 

Im new to this forum! just picked up a 2018 TRD Off Road.

I just swapped out the interior lights with LED's. Headlights also got an upgrade, Halogens are now LED's, and installed a Tailgate lock. Not too bad for day 1!

 

Finished Installing my axe/shovel mounts after getting a new shovel. Also added some new hand tools to the tool bag I keep in the truck.

 

Yes! Mine are side air bag compatible. And yes, I watched the same video when I installed them. I didn’t take my seats out, and it was still pretty easy with them in. FYI I ordered mine 5/19 and just got them on 8/11. I’m not sure how long it is now, but definitely worth the wait!

 

Sounds like you get stuck a lot.

Welcome to the Money Pit.

 

Ordered a Pro grill from MC Autoparts....kinda excited!