Manual transmission Fan Club and BS thread (All Generations Welcome)

One of you needs to hurry up and do the fj pedal swap so I’m guilted into doing it and you can laugh when I mess it up like I did the adm

 

Sounds nice

 

Not sayin a word lol

 

Anyone one hear ever hear a 3rd not starting? I depress the clutch and definitely have battery and no clicking or anything. Just dead. Have to depress the clutch a few times kicking the key back and forth.
Almost seems like the truck doesn't know the clutch is depressed. Just started happening yesterday, my truck is under warranty. Probably call the dealer tomorrow, but was wondering if anyone else ever ran into this issue?

 

If it happens again try the Clutch Start Cancel Switch to narrow down the problem.

 

The lower limit switch is probably out of adjustment. Should be a quick fix. There's instructions in the Service Manual linked in my signature, if you want to skip the trip.

 

Sorry, new to forums... How do I access this link?

 

It's the fifth link down in my forum signature, just below.

 

Factory floor mats?

 

Are you asking if I have factory floor mats?

I do but they are not in the truck right now.

 

because aftermarket floor mats can interfere with the switch. you'd have to push down super hard to engage, same happened to many including me.

 

I see what you are saying now that I looked. Thank you!

 

So it's fixed?

 

This same issue can be a head-scratcher when your taco will not go into 4-Lo. The clutch pedal must be to the floor otherwise you get an error. - Even lower than needed for a proper gear shift.

 

I hope so. I will throw my factory floor mats in this week and see if I have any more issues!

 

So I forgot to update this, been busy... I haven't had an issues since I put my factory floor mats back in. Thank you su. b. rat for the help!

 

Damn just found this thread. Fully loaded 2020 OR 4x4 6MT.

Just got 5.29 gears put on mine. Huge help especially in 1st or 2nd on these SF hills with 33’s.

 

I know it's a dumb question but are there tunes for manuals as well?

 

you mean, "is the Coyoza tune for MTs available in your area easily?"

https://www.tacomaworld.com/threads/coyoza-tune-development-and-feedback.719707/

 

Yeah,


just hold the skinny pedal down longer, ‘til the little needle gets closer to the red part…