What Have You Done To Your 3rd Gen Today?

I got these back from @BamaTaco56 earlier today. He replaced the shafts, seals and bearing on the rod ends. They are as good as new again. I am very pleased with his work. So glad that I didn't have to ship them cross country to have them rebuild. I recommend anyone in the Southeast region who is looking to rebuild their shocks, reach out to him.

 

what covers are these? Looks great!

 

Added a few new items to my truck today console organizer, neoprene like armrest cover (so I no longer burn my arm on it in this summer heat) and finally a Teton Workshop shift knob (man I love this thing).

 

Just put on my new black decals. Easy install and they look great.

 

That shift knob is sweet. Hhmmm. Now I might have to add that to my list.

 

It’s much better than stock made from aluminum and G10 knife handle material so it has some heft. Also made in the USA. https://tetonworkshop.com/

 

Took it out for some therapy

 

Received my 5160s this past week after waiting 2 months and installed those today. Had the cali raised shock skids to try out. They seem ok, not sure how much they’ll protect the shock shaft but better than nothing I suppose.

 

Put My New Plate on!

 

Replaced spark plugs to celebrate her first 100k milestone. Several extensions and swivels, and got away without having to remove intake parts. Wasn't fun, but it's done. Diffs, trans, and t-case fluids are probably next.

 

Helped a buddy detail his truck, clay bar on up to wax.

 

Put on TC bed stiffeners, mounted a 60” hi lift and shovel to the CBI rack, unboxed my SCS ray 10s in gunmetal grey and but them next to the deavers… just impatiently awaiting ADS to finish my shocks

 

Thanks! Here ya go
https://www.carid.com/rixxu/rixxu-camo-series-seat-covers-883608772.html

 

I got the same exact ones you have. Went on smooth, had a bubble in each big letter on one side for one day and it disappeared in the sun. I have also applied Mequirs Hybrid Ceramic wax over them with no ill results whatsoever. That red color had to go!

 

I see y'all had some great supervision as well.

 

More prep for the incoming RLD Canopy.

Completed cubby water / dustproofing. Installed mikwilla's cubby caps, pulled apart inverter side cubby and sealed plug unit to faceplate, and faceplate to cubby. Installed butyl tape between cubbys and bed. All nice and sealed up! Short of the tailgate gaps and pending tailgate seal there, have got this thing as water and dust tight as I imagine it will ever be.

Then ran 7 wire harness for capper from inside cubby junction box to under the hood, all nice an zip tied and following factory harness routing.

Had some time so installed terminals, soldered, labeled, heat shrinked, and landed all the wires from the harness.











Time for a beer.

 

Skid plates don't give enough protection?

 

Truck things...

 

Painted chrome letters to match my theme, and 1st use of the cap holder.

 

USAA would take care of that. Zero doubt.