Your unique mod on the 1st Gens

I wouldn't call it negative. Putting something in to "look" nice and cause other issue is definitely unique.

 

thanks ?

 

Camry handles?

 

No Chinese ebay stuff.
But they are actually not that bad. I reused the OEM springs because they were better. But over all came out ok.

 

where can i get that cupholder by your shifter? Thats pretty cool

 

yeap thats it. You got it. Its because the LEDs have side LEDs and one points right at it actually. But I also need to change battery for sure. Even if I dont. I want Optima Yellow Top

 

yes sir I love it! Here it is http://www.bh3dprinting.com/product/1996-2004-tacoma-double-cup-holder/

 

Yo dudes. New here.

Anyway, big Beksinski/ Giger fan so I did a little epoxy putty sculpt as a test run before blacking out my interior.

It's holding far better than I thought to the vinyl so we'll probably be adding bits of similar texturing around the dash.

Probably only be helpful to other weirdos but if you sculpt something and run lighting behind it, it could make for some cheap but heavily detailed interior mods.

 

what did you use on the grille shell?

 

Debating between getting the double or single cup holder. If you move let the passenger seat slam forward does the 2 cup holder ever snap off? I can see myself definitely forgetting and breaking some trim piece.

 

I've got the double cup holder. Never slammed the seat forward, but I did an experiment to answer your question.
My seat does brush up against the cup holder but not enough to move the mount at all.
I did only install with the 3M tape as I didn't want screw holes in my factory trim pieces.
Hope that helps a little.

Cheers!

 

I have custom seat mounts in my car and my seat is mounted further back for the passenger so they get more leg room. Never hits it

 

I’m sort of new here and this mod might be common, but I installed the single cup holder found on the full bench seat models in my ‘98 Taco 4x4 with 60/40 seats and auto trans. Works great. So have a total of 3 now but use this one the most.

 

what kinda rims and tires are you running?

 

Those wheels are long gone, sold them around 2007-2008 I think, on my 3rd set of wheels now.

Those were ProComp 1059s and I had the old BFG KM1 32" on them.

My current wheels.

 

Moved my Alpine rear camera from the license plate up to the tailgate latch using a manual Pop n Lock assy. Removed the lock to run wires through. Plan to add an auto lock later. Had enough room to run the camera wire without drilling any holes. All worked out well with the connection back to the Alpine ILX-650.

 

Most Excellent!

 

The Wyld Stallyns.

 

Someone had 4 buckets in a double cab I saw years ago. Looked really good.