SAS 3 link taco

Front: diamond housing,rcv axles,wfo 3 link,5.29 gears, e locker, arp studs for housing-hubs-high steer, 6shooters, chromoly hub gears inner/outer. King 2.5 coilovers with locked off-road hydro-bumps And more
Rear: diamond housing with 5.29 and e locker. Chromoly shafts. Chevy 63 and fox 2.0 and locked off-road hydro bumps. Frame has been plated/boxed and crossover bars. No rust whatsoever.
Truck has 190k miles with a clean title in hand. Motor and tranny both have less than 5k miles after rebuild(still have old 3.4 block in garage) Entire cab has been dynomatted and is quiet on the hwy. nice touchscreen head unit with navigation. Cold ac/hot heater. There’s tons more to list but that gives y’all a good understanding of the truck. It is built right drive it to the trail and back.


Asking price is 20k. truck is located in Socal
no rush to sell however im building a 4runner and dont need two rigs

 

You built the truck yourself or bought the truck built already?

 

my neighbor started it and I finished it.

 

You sure it's wfo 3 link as you mention? The heim joint, lower frame bracket and axle bracket don't look like wfo imo.
Chevy 63 rear with block?
Front and rear wms?
12 or 14 co?

A buddy is interested. What your contact?

 

ill message you

 

That’s dope, you sell it yet?

 

This looks so fun. GLWS

 

not yet

 

Looks like a blast of a truck, a hell of a lot more than I would ever need, too bad I don' have a few extra stacks laying around... GLWS

 

@thebstell What size diamonds are they?

 

I would venture to say they're probably both 8" third, if that's what you mean by "what size diamond are they" because of the 6 shooter. The center piece look small as well. All the guys I known who run 9.5 will run 80 outers instead.

 

Still available?