What Have You Done To Your 2nd Gen Tacoma Today?

Where did you get the little bracket that angles the light down? Looks great.

 

I appreciate it. I got them from here along with the lights:

https://www.4runnerlifestyle.com/collections/lighting/products/prinsu-roof-rack-handles

 

These are nice. I really like the ones from uptop overland also, but these are all really pricey. I just received these, amd though I have not installed yet, I think they will work out just fine and only $6 each. Once I get all the peices for my set up I'll post pics assuming ot works.
https://plashlights.com/products/angle-mount-for-rock-light?_pos=1&_sid=a7623350b&_ss=r

 

i apologize I actually had to throw out the old mesh grille and plastic surround. Hit a bird and busted her up pretty good! Thanks for the interest

 

I just had to comment on this. lost our lab about 4 months ago.(She was 14.50 years young) We have no children. Just wanted to say this is what life is about but I'm sure with over 20 likes you've already figured this out and I'm thinking you already knew this anyway! I'm thinking the dog likes the new home as much as y'all love her. Well done. Many years of enjoyment will follow! Beautiful Dog! Take Care!

 

Not when you win a $43k settlement. $1300 is like throwing a penny on the street. I’m a rapper now

 

Looking for one for my 2008. Which model is yours. Did you buy a dash kit. If so which one. Is there a supplier in the states. Seems like a lot of competition with Joying in the same price range. Joying seems to have consistent good reviews. Just don't want to wait for the slow boat from China.

 

Have to pull my front bumper again to mount my winch controller

 

Then throw a "penny" this way if it's such a lowly sum...

My point wasn't about the $, but about what you're getting for it. That bumper is hot garbage

 

Putting off air hammering the rivets on my hangers have the BAMF sitting in them basement

 

Cut the heads off and they drive right out no biggie. @EatSleepTacos thought of cutting the hangers off flush with the frame which will make the rivets even easier. Wish i'd have thought of that but too old and dumb.

 

That’s what my buddy did as well just a lot of work in the driveway hahah

 

Honestly I dont remember even using an air hammer. I cut the heads off, pried the hangers off, grund the rivets flush with the frame, and then just popped them out with a hammer and punch. Yes it is a bit of work but not awful

 

What he means is spend the time to research and get a nicer bumper. But bragging about your money is good too.

 

Where can I find one of these guys, but smaller?

 

Is it just me or does your bed look like it’s doing something a little sketchy?

 

Tested the Cooper Discoverer Rudded trek at Colliers Mills NJ. Factory wheels and suspension.

 

Bought this one (reason I chose this one because it had the “dot key” chip and same FCC ID for keyless entry as the 05-10 remote) and this programmer.
Programming for the keyless entry is the same as stock, but to program the key (with engine immobilizer chip) you have to use the key programmer I linked.

 

Also here is my post from a different thread including the threads I used.

 

Are they the 2 front doors and the 2 rear doors the same part number or is each door different? I only see Front Door LH and Rear Door LH listed on their site.
You had to order the handles and the rear covers as well, correct.