1st Gen Lunchtable Thread - General Discussion

On a happy note, I figured out how to align toe properly today with toe plates though it took 3-4 hours (will be way faster next time)

 

You'll be greatly dissapointed when you find out the rack doesnt clear the pointy bit at the end of the cam

I tried that too

 

A stepper drill bit makes easy work of that

 

She rubs a “little” bit

 

I already know it does
It pokes the rack dust boot but it fits

 

The dinner plates of leds on the bumper are nice

 

That's a good point, but I had hoped to keep it in tact to re-press.

 

When I did it it left a little burr that was big enough to retain the washer, than I tack welded it

 

Oh well you can do that just don't expect the rack boot to last all that long rubbing against a pointy bit

 

I'd say next time, but there won't be one

 

Yep, not a big deal imo. The trade-off is worth it.
Plus then I'll know immediately if the rack seals fail hah

 

VHT engine paint is the bomb

 

2nd week of school

Cutting with gasses begins today

 

That's so Emo Metal

 

Pay extra close attention to flame types, colors, length and spread.
Mastering the gas combination is key.
The rest is patience, steady hand and avoiding ALL contact with molten metal.

 

Cody is the man. Films all our meats

 

Can he film my meat?