What Have You Done To Your 2nd Gen Tacoma Today?

I would also like to see this evidence as well.......I have wheeled mine pretty hard with no issues.

 

not from that specific wheel because ive never seen anyone run them. But I have seen it on a lot of other brands, even methods. if your in the middle of nowhere its worth the extra money for a wheel that is stronger

 

those are skinny's that prob why you dont rub

 

That is one wet looking paint!

 

Wowzers! That is super shiny

 

Before I drive 7 hours to help my mom move…. I did a quick rear diff oil change, swap air filter, grease zirks, oil change this am. Man, changing the oil with a fumoto oil drain valve behind a steel skid plate is so easy…


Which makes up for the fact that my passenger CV boot is leaking like a son of a bitch.



So I swapped that out for a Napa spare that I carry on my wheeling trips. Next week I will reboot both oem CVs and get the Napa back in a case as a spare.


Possibly I will also clean off my skid

 

If I am honest with myself, the time plus cost of paint may have made it worth paying for powder coating. But then I would have to factor in the frustration of having the shipper possibly (likely?) destroy the powder coating. Oh well, hopefully I'll get these on later this week.

 

Would this work for key that have a G on it

 

No, you would need something similar to this. Basically in 2011(?) they changed the immobilizer chip in toyota keys. Mine is the "dot" immobilizer. You just need the correct one for your year, and then I'm pretty sure it is all the same steps.

 

Looks like me after a Mexican Restaurant.

 

Painting and repainting a few things today.

Painted the V2 dual maps black


And repainting the shifter bezel

 

Post again when you get the lights installed, might do mine if I like

 

Haven’t posted a pic of her in a while. Think she got jealous and threw an emissions code at me today. Hopefully just the gas cap. Here’s a pic to keep her satisfied

 

Tried to install extended brake lines yesterday in prep for my rear shock relocation this weekend. Got the fronts on but one flare nut is seized so bad on the rear I said screw it and ordered a new hard line so I can just cut it off. In a holding pattern on that till parts come in weds.



Then My meso dual color maps showed up today so I popped those in real quick.

 

Great idea! Been meaning to do mine

 

Hope you didn't get any black overspray on that new green Ford Maverick in the picture.

 

Lol

 

Nice, I did a bit of over spray and had to do another coat. Might be time to buy a OEM black one



Edit: clean

 

Eeeeeh, it's a Tacoma not a Ferrari

 

Here you go