AZ BS Thread 4²0

yo brotha. How you been?

 

I'm good. Busy as hell. Just finished 12 cars that were sent to Barret Jackson auction in Houston. On top of that setting up my plasma cutting table/side biz.
First paying job. Cutting Bad Shark sign.

How about you?

 

Damn 12 cars!? Nice work. And the plasma cutting is so soothing to watch.

We been good just working and living. Still enjoying it up here in show low. Just waiting on the snow so life can slow back down for a bit.

 

Finally.. been fighting this bitch ass part the last couple days...

 

Turned out great tho! How many you have to do total? And how many did you have to trash?

 

Thanks man! I need to make 5.. I scrapped 2. They want them fast so I was trimming the fat off the times.. getting more aggressive with the toolpaths.. and sent it a little too hard. One on Op1.. One on op2. Dialed it back and made some more changes.. now it's running good.

 

Oh that aint bad only 2. I would still be working on my first on. Glad you got her dialed

 

Isn’t there already things out that keep your tacos from tipping over on your plate?

 

these will handle the most loaded of tacos.

 

Here I thought it was for holding your phone while taking selfies of your balloon knot for your onlyfans.

 

Are you trying to put us hard working cameramen out of work?! Volunteer work looks great on my resume man.

 

Is taking photos of the A-noose volunteer work?
A lot of hairy ass dudes in here. At least make 20$ per mang.

 

Uh... I mean...


no? Of course I get paid!

 

Hey. Does anyone know general electrical stuff?

I cut holes and wired up the outlets for the behind the wall tv kit that hides the wires to the electronics and gives you an outlet behind tv. There is insulation in the wall. Not sure if it’s ok or if that’s a hazard and I need to cut it out. Bottom where power cord connects uses wing nuts and the top outlet is a normal outlet with power/neutral/ground wrapped around the screws

any help would be appreciated

 

Don’t know code or not, but if I was doing that install myself, I would get a shallow single gang box to screw at least the outlet part into so that the wires feed into it then connect to your device, so that the insulation doesn’t touch it, just peace of mind to me.

 

Ahh thanks. You are correct. They included two but only talk about it for new construction Just saw instructional pic a and looks like it’s on therd

 

20 dollars is 20 dollars!

 

Glad you got the box. 100% required by the NEC. Without the box you would light the insulation, and probably your entire house, on fire.

As a rule, all wire connections occur inside of an NEC approved junction box of some type. Without fail.

 

I guess I can officially consider myself an AZ resident now?



First well and truly cracked windshield, and the runner hasn't hit 3k yet.

 

O.H.S.O Monday meet 7 years ago