What Have You Done To Your 3rd Gen Today?

How are the CV shaft angles and how are the CV boot fins looking. Thinking of the same setup and wondering what I can get away with before adding a bumper and winch.

 

I haul lumber with mine a lot for DIY projects and was curious. Does it look like your roof comes down on the inside at all?

 

I'll have to look into it because now I really wish I'd added it. For some reason I remember thinking it was an option on one of the other ones I'd been looking at but not this one.

I ordered mine from Pennsingers in Bakersfield. http://www.pensingers.com/

 

Dayum, that's looking good!

 

I wish I could have the keyless entry on mine but mine has the older pop out lock style. Snugtop said I would have to replace the entire window with the new lock style to get the keyless entry. $500 for the entire window, no thanks!

 

Nice, I figured your profile pic looked like Socal desert. I ordered mine from Fuller Truck in Riverside. Hopefully this means Snugtop is starting to crank them out faster!

I even asked them about keyless entry for the windoors, but they don’t have that option yet (I wouldn’t spend another $500 for those to be on the FOB anyway).

 

Just got home from a Fall Beach trip to Corolla, NC / OBX.

Aired down Continental Terrain Contact H/T’s to 20 lbs. Packed 3 of us and 2 Labs into backseat. Removed seat bottom for the 2/3 rear section to manufacture room for the dogs. Also very pleased with VooDoo Bed Rack for my Thule box. Yakima bike rack.

These 7 wild horses made their way over to us. Pretty cool for first time on the beach!

Ocean was warmer end of September than any of our Summer trips to Corolla. Yesterday- 10/1- the whole beach in Currituck County opened for 4WDs. These pics were from the year round 4x4 beach.

 

More OBX Beach Driving

 

TBH you may want something bigger than a pancake. I say that because unless your’s has a 100 percent duty cycle you’re going to be doing a lot of waiting for the tank to refill in order to avoid burning up your compressor. The hopper holds whatever you’re spraying, in my case fluid film.

 

The roll bar is custom details in my build thread. Link below.

 

Everything is fine, and got back to normal alignment with no problem. Many people run this same set up and fortunately it isn’t required to upgrade the UCAs immediately either. Upgraded UCAs are suggested at 3”+ lift

 

Not sure if it's the angle of the pic, but is it green? Did you do it yourself?

 

Thanks, I have the same OME/Dakar setup on my 2nd gen and thinking of moving it to my 3rd gen. I know with my 2nd gen, CV angle and boot fin rub was an issue before adding the ARB and winch to the front end.

 

Lol, does kind of look green. Not sure if because red light or crap iPhone 8 but it’s black. My 12 yr old son helped by holding up the other end. Getting the spacers to line up was the toughest part. Just takes some patience.

 

What is it for, its purpose?

Thanks

 

thanx

https://www.tacomaworld.com/threads/tyta-trd-toyota-turd-build.706899/page-2#post-26313054

 

Damn 11! I think I only used 6 when I had my Chevy 2500 Crew Cab.

 

Switched out my glove box RED tacoma for Gray. I just had too much red going on inside.

 

Nothing serious so I won't add pics but finally put the Toyota black exhaust tip on my shortened tailpipe. Also added the Tacoma bed mat.

 

Got my truck sprayed for winter, woolwax from a guy I found locally he had my truck for two hours and did an outstanding job.