Wheel Bearings & Hubs Press Service *** OE NSK ***

Thank you again for the fast service

 

@knifer
Shipped

 

@MountainMaker
Shipped

 

Received, Thank you!

 

That's good haha
Thanks guys for your continued support!

 

@MJ1423
@WeekendWarrior
@HB Taco
@Dedroberts
Shipped

 

Awesome! Should I go ahead and get a set of seals? I dont beat on the truck too hard or have gone through many water crossings or mud. Just trying to see if most have replaced the seals while at it or not? Can you get away with cleaning them up? I suppose I could just get a set and have them on hand at least.

 

I recommend replacing them, almost always can use replacing. They keep incidental water from splashing up into the back of the bearing, they won't stop submersed water from entering and filling that void.

 

@DesertDonkey
Shipped

 

Returned from my vacation to find thes waiting for me !!! Thank you again - next weekend project.

 

@RAVDoug
@ponderosa
@Csharp987
Shipped

 

Absolutely great set of hubs/bearings. Thank you again truck has never driven/sounded this good great finish to my full front end rebuild.

 

Looks good!

 

Considering about converting to 4wd. Are these hub and bearings bolt on when i take the old ones off the knuckle?

 

Yes, PreRunner and 4x4 use the same knuckle.

 

@Surfr6
@Chrysalisbass03
@Blazze05
Shipped

 

@boostedka
Shipped

 

Just put the hub assemblies in and the groan noise at speed is gone. BUT now the brake pedal is soft on the first push then is fine after. As soon as I drive a block or two the same thing happens. I bled the brakes to no avail. In researching this issue some have said the new wheel bearings was the solution? Somehow this caused the problem (caused by runout causing the brake pads to back off?) Anyone else have this after doing the hub assemblies? It was done by a trusted local mechanic I found on here who specializes on these trucks and has done this many times. I assisted and everything went well as far as I could tell.

 

Bearing hub assemblies have nothing to do with your brakes, could you link to that post

 

That seems to be incorrect. I'm still trying to wrap my head around this issue. Here's one of many links you can find on the issue. Didn't have the problem before doing the bearings. We didn't do anything with the brakes except pull the calipers and rotors then reinstall them after? Hung the calipers without stressing the lines. I'm going to do a full brake fluid flush and hope that takes care of it. https://www.brakepartsinc.com/dam/jcr:3766693f-915f-4fce-8a51-05de7f91c309/TB 19-03.pdf. What they say here is exactly what I'm experiencing. Just soft when first applying the brakes. Fine on the 2nd push?