What have you done to your Tacoma today? 1st Gen Edition

The only one I have. The pump was on the bottom and the low level sensor was on the side.

 

Agreed. But I do remember seeing him post about a road course. Don't buy a 60k car if you can't afford to wreck it. Buy a 6k taco and a 30k s2k, that's just me though.

 

I don't have any good pics of it mounted, it's just zip ties.

 

just do the pre taco swap. Works awesome.

otherwise: https://www.tacomaworld.com/threads...trail-rig-and-bs.159436/page-398#post-8802626

Id recommend using hose clamps instead of zip ties for holding it around the frame. Zip ties are fine everywhere else.

 

Thanks. Can't do the pre-taco since I have both ABS and CC. My engine bay is super crowded. Evap stuff on the other side too. Easier access than you I suppose for that, but still, I'd love more space. Thx for the link, yours was the one I remembered, but couldn't find it in Igor's build.



And here's why I had to remove the reservoir. It was for *another* reservoir, hahahaha. So nice to get them off the top of the frame rails. Was a pain to get them positioned and clamped in up there. (obviously on the other side)

Even better. Thanks dude!

 

ahh nice. Moved the resi's. I don't think they are too bad to remove now anyways. Also...i didn't have to remove my washer tank for the my resi's...

Wow yeah you don't have shit for room for that hahaha

Seen people do what Ben Did with the Nalgen with just PVC too.

 

Hey guys, anyone here good at electrical stuff? I think I shorted some thing out and my driver side turn signal and marker light wires aren’t getting any power. I’ve tried replacing the relay but it did nothing…pls help

 

Did you check your fuse?

 

You have a pic of the passenger side?

 

Yeah, I had to remove my washer fluid bottle too. I went the Nalgene bottle route as well.

 

Another option for those looking to fix the fluid reservoir situation.

https://optoffroad.com/collections/...servoir-relocation-kit?variant=32521839771695

 

Hm maybe. I'll have to look.

 

Yes of course, all the fuses are OK and the hazard lights hyper flash…

 

Do you have a trailer harness converter by chance? They cause all kinds of odd light behaviour when they fail

 

I do actually! I’ll pull it out and see if that helps. Thanks for the lead!!! excited to see what happens

 

Your engine bay makes my dick hard.

That zip tie limit strap though. Has anyone run this mounting configuration with 35's yet?

And this morning I swapped a cv, no pics cause it's boring to most people anymore ha.

 

OK, it's been a few days ago but I moved my Alpine camera from the license plate up to the tailgate latch and installed a new Pop & Lock power lock:

 

hopefully you can see these:

 

Not that exact hose configuration, and not the MGM resi brackets, but my resi’s are in approximately the same spot with the stock hoses. Plenty of clearance with 35’s with 2.5” total backspace.

 

Smoked them boys what are you running under the hood?