1st Gen Lunchtable Thread - General Discussion

Are these bump stops supposed to turn out or is Toyota messing with my head?

 

Pipe wrench, and they'll unscrew right off.

They have a bolt coming out the bottom that screws into a factory welded nut in the LCA.

 

Awesome. Thanks!

 

Yeah they come off pretty easy surprisingly enough.

Durobump stops are awesome, but if you're not wheeling, not worth upgrading them.

Careful that the nut doesn't break like it did for @eon_blue

He's got that fucker JB welded on the driver side

 

Yeah that weld nut inside the arm will snap off pretty easily, careful

 

What’s the advantage of the durobumps? Softer landing when you bottom out?

 

Aww, and it happened during a magazine shoot too lol

 

https://sadtrombone.com/

 

Straight like that!

The missus would never give me an ultimatum like that but video games fill the loneliness well enough lol

 

Starts slowing you down sooner so you don't smack hard durometer rubber at mach 1

 

Might be worth it. Definitely done that a couple times.

 

I never managed to get mine off, even with a pipe wrench. I think most people ignore the fender washers from Bilstein/OME

 

But that just dents your frame stop and gives you more down travel

 

WTF! Ford's fault or yours?

 

WTH just happened
Bronco:

 

Definitely not mine, my guess is Motor trend went too hard on the light duty little guy

 

Hmm and here I was hearing all good things about it

 

It's got lots of room for the aftermarket to make it into a beast

 

I broke them loose with the bench vise, then turned them with the pipe wrench till they were easy enough to turn by hand. Wasn’t too bad.


What fender washers?