What size switch blanks are needed for MESO panels?

Specifically the CP4P and LSP7 panels. I was finally able to get these from @MESO but now I need to fill in the holes. Anyone have a source AND know which size they require by chance? It visually looks like both panels use the same button sizes.

 

https://mesocustoms.com/collections/3d-printed-products/products/3rd-gen-tacoma-custom-made-switch-panel?variant=20230657802353

All the info you need is on Meso’s site…

 

They are size “B”. Which is the standard “small” Toyota switch. I have blanks available on the website HERE

 

@MESO thank you for replying! I just removed the factory cubby panel and discovered that one of the switches is the longer one (clutch cancel). Do you have a cubby panel just like the CP4P but where one of the holes is the larger one by chance? It is not a normal switch so I can't replace it with a smaller one, it has electronics behind it and a long body that sticks back towards the engine and 4 little pins for a connector. So frustrating to be SO close and yet so far...

 

So here is the problem. I got the Meso panel which is perfect except that I need one of the buttons to be the larger size here is a side by side pic of both panels. Anyone know if there is a replacement small switch for the clutch button?

 

Turns out the tall button is the clutch cancel switch, and there is no small button replacement because it has a long body with electronics inside that consists of a relay and some electronics to automatically turn itself off under certain conditions. In the mean time someone pointed out that Meso does custom panels, so guess I will need to return this panel and get the correct one. Sure hope they are able to do this for me!

/sad