What Have You Done To Your 3rd Gen Today?

How’s the smell? Did he do a good job not getting any overspray on your exhaust?

 

Hey where’d you get your bedside decal?

 

Chapman is the tool brand you want!

 

Nice. Made in Connecticut. Better than made in the Amazon.

 

Have had mine sitting around forever. I have to install them. Do you have a link for the tool? Did you have to take anything else off aside from the grill?

 

Just saw thanks

 

Seems most folks either don’t know how to properly weave MOLLE or they underestimate the pain in the ass level of properly weaving while a panel is fixed in place. I pull my panels off 90% of the time to attach things- quicker in the long run and much less frustrating.

 

Physically installed fog lights but am debating about doing the nitori not prewired mod or having them turn on with the low beams via a tap and relay….. I’ll probably end up doing the nitori mod after I read (and re-read and re-read again x5) his thread….

also brushed on ncp2 on my quad hella horn connections, great stuff and a spray can (though the brush on stuff is better and more accurate less messy) will probably last your entire life for general casual use. Great for battery terminals too.

 

Those WeatherTech floor liners look super nice, They look like the new HP's.

 

Im not sure on the HP, but i have had Husky liners in the past and these are by far much nicer.

 

Nice. I’ll install mine tomorrow and post a pic.

 

Installed:
OEM LED toyota trd pro headlights
the taco garage trd pro grille with raptor lights

 

yeah the diamond back seems to limit the bed racks. How was the install? Seems like a lot of drilling into your new cover lol

 

Looks good. I just hate the idea of drilling into my door

 

Another option if you already have the cleats installed is the UpTop Truss Bed rack: https://www.uptopoverland.com/products/tacoma-diamonback-truss-bed-rack-2018-2021

 

Link?

 

yeah I haven’t ordered a DB yet. Probably going to order the smooth with cleats just so I don’t have to install them later. Clean does look good though

 

why can’t you just use a normal screwdriver

 

$16 Chapman CM-13 RATCHET 1/4 DRIVE CHAPMAN

https://www.amazon.com/dp/B00FVYLJ8W?_encoding=UTF8

 

I also had to unclip the fender flares from the bumper caps to be able to rotate them down to get access.